Sony VG-PPRFS10V User Manual

Port Replicator
VGP-PRFS10V

Operating Instructions
Manual de instrucciones

© 2005 Sony Corporation Printed in China2-630-644-11(1)

WARNING

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that any changes or modifications not expressly approved in this

manual could void your authority to operate this equipment.
Only peripherals (computer input/output devices, terminals, printers, etc.) that
comply with FCC Class B limits, may be attached to this computer product. Operation
with non-compliant peripherals is likely to result in interference to radio and television
reception.

All cables used to connect peripherals must be shielded and grounded. Operation with
cables, connected to peripherals, that are not shielded and grounded, may result in
interference to radio and television reception.

If you have any questions about this product, you can reach the Sony Customer
Infomation Service Center at 1-888-476-6972 in the United States or 1-800-961-7669 in
Canada; or write to the Sony Customer Information Service Center at 12451 Gateway
Blvd, Ft. Meyers, FL 33913, or find Sony Customer Service on the Web at
http://www.sony.com/pcsupport.

Declaration of Conformity
Trade Name: SONY
Model No.: VGP-PRFS10V
Responsible Party: Sony Electronics Inc.
Address: 16450 W. Bernardo Dr., San Diego,

CA 92127 U.S.A.
Telephone No.: 858-942-2230
This phone number is for FCC-related matters only.

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.

Power requirements

Operating temperature

Operating humidity

Storage temperature

Storage humidity

Dimensions Approx. 15.3 (w) × 1.5 (h) × 8.5 (d) inches

Mass Approx. 58.2 oz. (1.65 kg)

Supplied accessories

*1

Connector specifications are the same as those for your notebook. For more details, refer to the
manuals provided with your notebook.

*2

Use the PCGA-AC19V9 for this unit.

*3

Use the MPA-AC1 for the speakers.

Design and specifications are subject to change without notice.

AC adapter for the port replicator

Input: 100-240 V AC, 50/60 Hz
Output: 19.5 V DC. 7.7 A

AC adapter for the speakers

Input: 100-240 V AC, 50/60 Hz
Output: 12 V DC, 3 A

41°F to 95°F (5°C to 35°C)
(temperature gradient less than 18°F (10°C)/hour)

20% to 80% (not condensed), provided that humidity is less than
65% at 95°F (35°C) (hygrometer reading of less than 84°F (29°C))

–4°F to 140°F (–20°C to 60°C)
(temperature gradient less than 18°F (10°C)/hour)

10% to 90% (not condensed), provided that humidity is less than 20%
at 140°F (60°C) (hygrometer reading of less than 95°F (35°C))

(Approx. 387 × 36 × 214 mm)

Speakers (L, R 1 each)
MPA-AC1 AC adapter for the speakers (1)
Antenna cord (1)
Remote Commander (1)
Size AA (R6) batteries (2)
IR receiver (1)
PCGA-AC19V9 AC adapter for the port replicator (1)
AC power cord (2)
Operating instructions (1)

*2

*3

English

WARNING

To prevent a fire or shock hazard, do not expose the unit to
rain or moisture.

To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.

• Use your product only with the AC adapter supplied with this unit.

•To disconnect it completely from the main voltage, unplug the AC adapter.

• The socket - outlet shall be installed near the equipment and shall be easily
accessible.

For customers in the USA
Owner’s Record

The model number and serial number are located on the bottom of your port
replicator. Record the serial number in the space provided here. Refer to the model
and serial number when you call your Sony Service Center.
Model No. VGP-PRFS10V
Serial No. ___________________

VAIO and

are trademarks of Sony Corporation.

Before use

Before using the port replicator, please read this manual thoroughly and retain it for
future reference. See also the manuals provided with your notebook for more
information about connecting the port replicator.
The Sony VGP-PRFS10V port replicator is designed for Sony notebooks. However, it
may not be used with some models.

Specifications

Connectors

Port replicator connector: Custom connector (1)
USB: Type-A connector (4)*
Network (LAN) connector: 100 BASE-TX/10 BASE-T (1)*
External display output: MONITOR (a): Analog RGB,

Optical digital audio output: Square optical connector jack (1)

Stereo headphone output: Stereo mini-jack (1)
Stereo audio input: Pin jack (1)
Video input: NTSC support, pin jack (1)
S-Video input: NTSC support, S-Video connector (1)
TV antenna input: 75Ω, F-type connector (1)

1

1

Mini D-SUB 15-pin (1)

(EIAJ CP1201/IEC958 compliant)

Notes on use

• Use only the supplied PCGA-AC19V9 AC adapter with this unit, and only the
supplied MPA-AC1 AC adapter with the speakers.

•To disconnect the unit completely from the main voltage, unplug the AC adapter.

• Make sure that the socket outlet is easily accessible.

• Do not place the unit in locations that are:
– Extremely hot or cold
– Dusty or dirty
– Very humid
– Vibrating
– Subject to strong magnetic fields
– Sandy
– Subject to direct sunlight

• Do not apply mechanical shock or drop the unit.

• Make sure that nothing metallic comes into contact with the metal parts of the unit.
If this happens, a short-circuit may occur and the unit may be damaged.

• Do not operate the unit with a damaged cord.

• Do not operate the unit if the unit itself has been dropped or damaged.

• Always keep the metal contacts clean.

• Do not disassemble or convert the unit.

• While in use, it is normal for the unit to get warm.

• Keep the unit away from TV or AM receivers, because it can disturb TV or AM
reception.

• USB, i.LINK, PC-card slot and DVI-D are not supplied with Limited Power Sources
if those connectors are provided.

• When connecting or disconnecting the unit, handle it carefully.

• When transporting the unit, prevent foreign objects from causing a malfunction by
using the battery pack, the connector covers and the supplied slot protectors if
there is any.

• When transporting your notebook computer, be sure to remove the unit first.
Moving your notebook with the unit installed could cause the unit to fall off,
resulting in personal injury, or damage to the unit or your notebook.

On cleaning

Clean the unit with a soft dry cloth or a soft cloth lightly moistened with a mild
detergent solution. Do not use any type of solvent, such as alcohol or benzine, which
may damage the finish.

Español

Nombre del producto: Replicador de puerto
Modelo: VGP-PRFS10V

AVISO

Para evitar el riesgo de incendios y electrocución, no exponga
la unidad a la lluvia ni a la humedad.

Para evitar descargas eléctricas, no abra el aparato. Solicite
asistencia técnica únicamente a personal especializado.

IMPORTANTE!

POR FAVOR LEA DETALLADAMENTE ESTE MANUAL DE INSTRUCCIONES ANTES DE CONECTAR
Y OPERAR ESTE EQUIPO.

RECUERDE QUE UN MAL USO DE SU APARATO PODRÍA ANULAR LA GARANTÍA.

• Utilice el producto únicamente con el adaptador de CA suministrado con esta
unidad.

• Para desconectarlo totalmente de la corriente principal, desenchufe el adaptador de
CA.

• La toma de corriente deberá estar instalada cerca del equipo y se deberá poder
acceder a ella con facilidad.

VAIO y

són marcas comerciales de Sony Corporation.

Humedad de almacenamiento

Dimensiones

Peso

Accesorios suministrados

*1

Las especificaciones del conector coinciden con las del ordenador portátil. Para obtener más
información, consulte los manuales de instrucciones suministrados con el ordenador portátil.

*2

Utilice el modelo PCGA-AC19V9 con esta unidad.

*3

Utilice el modelo MPA-AC1 para los altavoces.

El diseño y las especificaciones están sujetas a cambios sin previo aviso.

10% a 90% (sin condensación), siempre que la humedad sea
inferior al 20% a 60°C (140°F) (lectura de higrómetro inferior a
35°C (95°F))

Aprox. 387 (an) × 36 (al) × 214 (pr) mm
(Aprox. 15,3 × 1,5 × 8,5 pulgadas)

Aprox. 1,65 kg (58,2 oz.)

Altavoces (Izquierdo, derecho (uno de cada))
MPA-AC1 Adaptador de CA para los altavoces (1)
Cable de antena (1)
Mando a distancia (1)
Pilas de tamaño AA (R6) (2)
Receptor de infrarrojos (1)
PCGA-AC19V9 Adaptador de CA para el replicador de puerto (1)
Cable de alimentación de CA (2)
Manual de instrucciones (1)

Antes del uso

Antes de utilizar el replicador de puerto, lea este manual detenidamente y consérvelo
para consultarlo en el futuro. Asimismo, para más información sobre cómo conectar el
replicador de puerto, lea los manuales suministrados con el ordenador portátil. El
replicador de puerto VGP-PRFS10V de Sony está diseñado para ordenadores portátiles
Sony. Sin embargo, es posible que no todos los modelos puedan utilizarlo.

Especificaciones

Conectores

Requisitos de alimentación

Temperatura de funcionamiento

Conector del replicador de puerto: Conector personalizado (1)
USB: Conector de tipo A (4)
Conector de red (LAN): 100 BASE-TX/10 BASE- T (1)
Salida de pantalla externa: MONITOR (a): RGB analógico,

Salida de audio digital óptica: Toma de conector óptico cuadrado (1)

Salida de auriculares estéreo: Minitoma estéreo (1)
Entrada de audio estéreo: Toma PIN (1)
Entrada de vídeo: Compatible con NTSC, toma PIN (1)
Entrada de S-Vídeo: Compatible con NTSC, conector de S-Vídeo (1)
Entrada de antena del televisor: 75Ω, conector de tipo F (1)

Adaptador de CA para el replicador de puerto

Entrada: 100-240 V CA, 50/60 Hz
Salida: 19,5 V CC 7,7 A

Adaptador de CA para los altavoces

Entrada: 100-240 V AC, 50/60 Hz
Salida: 12 V CC, 3 A

5°C a 35°C (41°F a 95°F)
(cambios de temperatura inferiores a 10°C (18°F)/hora)

*1

*1

Mini D-sub de 15 pines (1)

(compatible con EIAJ CP1201/IEC958)

*2

*3

Notas sobre el uso

• Utilice únicamente el adaptador de CA PCGA-AC19V9 suministrado con esta
unidad y el adaptador de CA MPA-AC1 con los altavoces.

• Para desconectar totalmente la unidad de la corriente principal, desenchufe el
adaptador de CA.

• Asegúrese de que la toma de corriente es de fácil acceso.

• No coloque la unidad en lugares:

– extremadamente cálidos o fríos
– polvorientos o sucios
– muy húmedos
– con vibración
– con fuertes campos electromagnéticos
–arenosos
– expuestos a la luz solar directa

• No golpee ni deje caer la unidad.

• Asegúrese de que ningún objeto metálico entre en contacto con las partes metálicas
de la unidad, ya que podría producirse un cortocircuito y la unidad podría
dañarse.

• No utilice la unidad con un cable dañado.

• No utilice la unidad si se ha caído o dañado.

• Mantenga siempre limpios los contactos metálicos.

• No desmonte ni modifique la unidad.

• Durante el uso, es normal que la unidad se caliente.

• Mantenga la unidad alejada de los receptores de TV o AM, ya que puede dificultar
la recepción.

• Al conectar o desconectar la unidad, manéjela con cuidado.

• Cuando transporte la unidad, utilice la batería, las cubiertas de los conectores y los
protectores de las ranuras (si los hubiera) suministrados para evitar que algún
objeto extraño provoque un fallo de funcionamiento.

• No olvide extraer la unidad cuando vaya a transportar el ordenador portátil. Si no
lo hace, la unidad podría caerse y causar daños personales o daños en la unidad o
en el ordenador.

Limpieza

Limpie la unidad con un paño suave y seco o ligeramente humedecido con una
solución de detergente neutro. No utilice ningún tipo de disolvente, como alcohol o
gasolina, que pueda dañar el acabado.

Humedad de funcionamiento

Temperatura de almacenamiento

20% a 80% (sin condensación), siempre que la humedad sea
inferior al 65% a 35°C (95°F) (lectura de higrómetro inferior a 29°C
(84°F))

–20°C a 60°C (–4°F a 140°F) (cambios de temperatura inferiores a
10°C (18°F)/hora)