Sony VGN-CS385J, VGN-CS390J, VGN-CS390, VGN-CS325J, VGN-CS320J Replacement Instructions

...
VGN-CS Series Optical Disk Drive Replacement Instructions
These easy instructions are intended to guide you through the replacement process. If you need additional help, please call 1-866-651-7669 for technical support from 9:00 am to 11:00 pm EST.
9 To av oid electric shock please make sure product is turned off and AC Adaptor is disconnected
* Sony is not responsible for any loss of data associated with your computer or any damage caused by incorrect handling of the computer under these procedures. The terms of your Sony Limited Warranty continue to apply.
from the power source. Remove jewelry before you begin work to av oid scratching the surface o f your notebook computer.*
9 Place your notebook computer on a clean, stable and covered surface to avoid damage to the
computer's case.*
9 Follow the ESD (Electrost atic Discharge) damage prevention instructions:
o Hold parts by the edges, away from exposed circuitry when possible. o Do not walk around excessively as this promotes static build-up.
9 The appearance of the electronic components shown in the i llustrations may be different from the
components shipped. This slight difference does not affect the accuracy of these instructions.
PLEASE READ BEFORE YOU START
IMPORTANT!
1. 2.
3.
Step 1. Prepare the Computer.
CAUTION: Make sure the
Place the computer upside down on a protected surface with the front edge facing you.
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N 994660000 Rev. A 1/2
Step 2. Remove the Battery Pack. Locate the release tab as shown in
the picture.
1. Slide the left battery tab to the Unlock position.
2. With your finger slide the right battery tab in the release direction and hold.
3. Hook your finger under the battery pack and lift.
(ODD Removal) Steps 3-6
Step 3. Locate ODD Bay
Rotate the computer with the Optical Disk Drive (ODD) Bay facing you as shown in the picture.
VGN-CS Series Optical Disk Drive Replacement Instructions
(Look for the screw hole with 3 dots)
Step 4. Using the enclosed magnetic
screwdriver, remove the one (1) screw securing the optical drive.
(ODD Reinstallation) Steps 7-11
Step 7. Install New Optical Drive.
Hold the new optical drive by the edges and align it with the bay opening.
Step 5. To initiate the removal of the optical drive, slightly pull the optical drive door as shown in the picture.
Step 8. Carefully slide the optical drive into the bay and back into place.
Step 6. With even force carefully remove the optical drive by pulling it away from the unit.
Step 9. To ensure proper assembly and connection, with even force push the ODD back into place.
(Optical drive should be sitting flush with the edge of the computer)
Step 10. IMPORTANT! Make sure
the screw hole is aligned before re-installing screw.
Step 11. Re-install the previously
removed screw.
Step 12. Re-install the battery pack.
Return the old ODD Bay to Sony following the included shipping instructions.
FOR TECHNICAL SUPPORT IN THE US CALL TOLL FREE 1-866-651-7669 FROM 9:00 AM TO 11:00 PM EST
P/N 994660000 Rev. A 2/2
Loading...