Sony VAIO PCGVX89 User Manual

PCG-VX89/VX89K/VX89P
SERVICE MANUAL
Ver 1-2002J
Revision History
Lineup : PCG-VX89P
Illust : PCG-VX89P
For American Area
US Model
Canadian Model
S400
Confidential
• Design and specifications are subject to change without notice.
9-876-021-01
NOTEBOOK COMPUTER
Information in this document is subject to change without notice.
Sony, VAIO and CLIE are trademarks or registered trademarks of
Sony. Microsoft, Windows, Windows Media, Outlook, Bookshelf
and other Microsoft products are trademarks or registered trademarks
of Microsoft Corporation in the United States and other countries.
The word Bluetooth and the Bluetooth logo are trademarks of
Bluetooth SIG, Inc. AMD, AMD logo, AMD Duron and
combinations thereof, 3DNow!, are trademarks of Advanced Micro
Devices, Inc. Intel Inside logo, Pentium and Celeron are trademarks
or registered trademarks of Intel Corporation. Transmeta, the
Transmeta logo, Crusoe Processor, the Crusoe logo and
combinations thereof are trademarks of Transmeta Corporation in
the USA and other countries. Graffiti, HotSync, PalmModem, and
Palm OS are resistered trademarks, and the Hotsync logo and Palm
are trademarks of Palm, Inc. or its subsidiaries. (M) and Motrola
are trademarks of Motrora, Inc. Other Motrola products and services
with (R) mark like Dragomball are the trademarks of Motrola, Inc.
All other names of systems, products and services in this manual
are trademarks or registered trademarks of their respective owners.
In this manual, the (TM) or (R) mark are not specified.
Caution Markings for Lithium/Ion Battery - The following or similar
texts shall be provided on battery pack of equipment or in both the
operating and the service instructions.
CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by
the manufacturer. Discard used batteries according to the
manufacturer’s instructions.
CAUTION: The battery pack used in this device may present a fire
or chemical burn hazard if mistreated. Do not disassemble, heat
above 100°C (212°F) or incinerate.
Dispose of used battery promptly.
Keep away from children.
CAUTION: Changing the back up battery.
• Overcharging, short circuiting, reverse charging, multilation or
incineration of the cells must be avoided to prevent one or more of
the following occurrences; release of toxic materials, release of
hydrogen and/or oxygen gas, rise in surface temperature.
• If a cell has leaked or vented, it should be replaced immediately
while avoiding to touch it without any protection.
Service and Inspection Precautions
1. Obey precautionary markings and instructions
Labels and stamps on the cabinet, chassis, and components identify areas requiring special precautions. Be sure to observe these precautions, as well as all precautions listed in the operating manual and other associated documents.
2. Use designated parts only
The set’s components possess important safety characteristics, such as noncombustibility and the ability to tolerate large voltages. Be sure that replacement parts possess the same safety characteristics as the originals. Also remember that the 0 mark, which appears in circuit diagrams and parts lists, denotes components that have particularly important safety functions; be extra sure to use only the designated components.
3. Always follow the original design when mounting parts and routing wires
The original layout includes various safety features, such as inclusion of insulating materials (tubes and tape) and the mounting of parts above the printer board. In addition, internal wiring has been routed and clamped so as to keep it away from hot or high-voltage parts. When mounting parts or routing wires, therefore, be sure to duplicate the original layout.
4. Inspect after completing service
After servicing, inspect to make sure that all screws, components, and wiring have been returned to their original condition. Also check the area around the repair location to ensure that repair work has caused no damage, and confirm safety.
5. When replacing chip components...
Never reuse components. Also remember that the negative side of tantalum capacitors is easily damaged by heat.
6. When handling flexible print boards...
• The temperature of the soldering-iron tip should be about 270C.
• Do not apply the tip more than three times to the same pattern.
• Handle patterns with care; never apply force.
Caution: Remember that hard disk drives are easily damaged by vibration. Always handle with care.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ! LES COMPOSANTS IDENTIFÉS PAR UNE MARQUE 0 SUR LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
— 2 —
Confidential
PCG-VX89/VX89K/VX89P (AM)

TABLE OF CONTENTS

Section Title Page
CHAPTER 1. BLOCK DIAGRAM ............................... 1-1
(to 1-2)
CHAPTER 2. FRAME HARNESS DIAGRAM ........ 2-1
(to 2-2)
CHAPTER 3. EXPLODED VIEWS AND
PARTS LIST............................................ 3-1
3-1. Main Section .................................................................... 3-2
3-2. LCD Section – Made by HI – .......................................... 3-5
(to 3-6)
History of the changes is shown as the
Revision History at the end of this data.
3
Confidential
PCG-VX89/VX89K/VX89P (AM)
CNX -176
RJ-45
VGA CN
CN15P
CHAPTER 1.
BLOCK DIAGRAM
14.1XGA
Intel Pentium
III
-m
90 0MHz
LV
30p
DV 0
CN
15 P
CN
15 P
Intel 82815EM-T
CN 4 P
Intel
DA82562ET
GMCH2-m
Memory Bus PC=100
LCD &
Inverter
SONY
VCH
Intel /
FW82807A
A
1
256MB Tech
256MB DIMM
W-LAN
MiniPCI
Module
Type
III
IFX-209( Left)
Ant L
(Sub)
Ant R (Main)
IFX-208(Right)
CNX -173
MODEM
Conexant
Smart MC2
USB CN
CN4P
i .LINK
USB 1 . 1
W-LAN SW
USB 1 . 1
CN 17 P
CN 17 P
i.Link
PCI Bus
Mini P CI
Connector
TypeIII
TSB43AB
CN 10 0 P
CN 10 0 P
DC out
Ultra ATA66/100
HDD
2P
CN
2P
CN 50 P
CN
PCI
22
Clock Generator
IMI/C9835AT
CardBus/16bitCard
Card con troller RICOHR5C475II
MBX-56
Intel 82801BAM
FWH
SST
ICH2-m
LPC Bus
PC Card Connector
1 Slot
49LF004A
JogDial
CN 30P
CN 30P
AC Link
Audio Codec
(AC '97)
Amp
USB 1 . 1
Encoder
KBC/EC
HITACH
H8/2149
I/ O
Expander
O2MICRO
OZ99 8S
ATF
AD1030A
CN 2P
FAN
CN 2P
CN
3P
FLT-7
CN 2 P
CN 2 P
RJ 1 1
CNX-174
USB C N
CN4P
USB 1 . 1
MIC CN
CN 30 P
CN 30 P
HeadPhone
1
CN
STmicr o
M29W200BB70N6
Memorystick
CN 14 P
CN 14 P
USB 1 . 1
Memoryst ick
Controller
Slot
IFX -207
CN
2P
SP(L )
CN
12 P
TouchPad
CN 7 P
JOG
CN 30 P CN24P
CN 30 P
Back
Botto n
CN 2P
SP(R )
SWX-101
CN 8P
CN 8P
Ke y B oard
Power SW
SWX-103
CN6P CN6P
Battery
11.1V/3600mAh
Confidential
1-21-1
(END)
PCG-VX89/VX89K/VX89P (AM)
Loading...
+ 7 hidden pages