Sony SRS-XB13 Users guide

5-025 -467-91(1)

Wireless Speaker

Reference Guide

SRS-XB13

©2021 Sony Corporation
Printed in China
https://www.sony.net/

English Wireless Speaker

Before operating the unit, please read this guide thoroughly and retain it
for future reference.
Please access the following URL and read the contents of the END USER
LICENSE AGREEMENT.
https://rd1.sony.net/help/speaker/el21/en2/

CAUTION

Do not expose the appliance to naked flame sources (for example,
lighted candles).

Do not install the appliance in a confined space, such as a bookcase or
built-in cabinet.

Do not expose the batteries (battery pack or batteries installed) to
excessive heat such as sunshine, fire or the like for a long time. Do not
subject the batteries to extreme low temperature conditions that may
result in overheating and thermal runaway. Do not dismantle, open or
shred secondary cells or batteries. In the event of a cell leaking, do not
allow the liquid to come in contact with the skin or eyes. If contact has
been made, wash the affected area with copious amounts of water and
seek medical advice. Secondary cells and batteries need to be charged
before use. Always use the correct charger and refer to the
manufacturer’s instructions or equipment manual for proper charging
instructions. After extended periods of storage, it may be necessary to
charge and discharge the cells or batteries several times to obtain
maximum performance. Dispose of properly.

Do not place this product close to medical devices

This product (including accessories) has magnet(s) which may interfere
with pacemakers, programmable shunt valves for hydrocephalus
treatment, or other medical devices. Do not place this product close to
persons who use such medical devices. Consult your doctor before using
this product if you use any such medical device.

This equipment has been tested and found to comply with the limits set
out in the EMC regulation using a connection cable shorter than
3meters.

Caution on charging

Inserting the USB plug while it is wet may cause a short circuit due
to foreign matter or liquid (tap water, salt water, soft drinks, etc.)
getting on the main unit or charging cable. This may cause
malfunctions or abnormal overheating.

Never insert the USB plug while the main unit or
charging cable is wet.

Precautions

On safety

• Important information such as the model name is located on the
bottom of the unit.

On placement

• To eliminate the risk of malfunctions, avoid the following locations
when placing or leaving this unit.

– A place subject to high temperatures, such as under direct sunlight or

lighting equipment, near a heat source, or in a sauna
– Inside a vehicle with the windows closed (especially in summertime)
– A place subject to excessive dust
– A place subject to strong vibration

• Place this unit on a flat, level surface. When placed on a sloped surface,
the unit may fall over or fall off the surface due to its own vibration,
resulting in injuries, malfunctions, or performance degradation.

• Depending on the conditions where this unit is placed, it may fall over
or fall off the surface. Do not leave any valuables near the unit.

• This unit is not anti-magnetic. Keep objects susceptible to magnetism
(recorded tapes, watches, cash cards and credit cards with magnetic
coding, etc.) away from the unit. When you carry around the unit, keep
this in mind as well.

Others

• Do not use or leave the unit in an extremely cold or hot environment
(temperature outside the range of 5 °C – 35 °C). If the unit is used or left
in outside the above range, the unit may automatically stop to protect
internal circuitry.

• At high temperature, the charging may stop or the volume may reduce
to protect the battery.

• Even if you do not intend to use the unit for a long time, charge the
battery to its full capacity once every 6 months to maintain its
performance.

On Copyrights

• Android is a trademark of GoogleLLC.

• The BLUETOOTH® word mark and logos are registered trademarks
owned by BluetoothSIG,Inc. and any use of such marks by
SonyCorporation is under license.

• iPhone, iPod and iPod touch are trademarks of Apple Inc., registered in
the U.S. and other countries.

• USB Type-C® and USB-C® are registered trademarks of
USB Implementers Forum.

• Other trademarks and trade names are those of their respective
owners.

• ™ and ® marks are omitted in the documents.

Notes on waterproof and dustproof
features (Read before using the unit)

Waterproof and dustproof performance of the unit

The unit, with the cap closed securely, has a waterproof specification of

1

as specified in “Degree of protection against water immersion” of

IPX7*
the IEC60529 “Ingress Protection Rating (IP Code)”*
specification of IP6X*
solid foreign objects”*

Liquids that the waterproof performance specifications
apply to

Applicable fresh water, tap water, pool water

Not applicable liquids other than the above (soapy water, water

1

IPX7 (Degree of protection against water immersion): For details, refer

*

to the Help Guide.

2

IP6X (Degrees of protection against dust): For details, refer to the Help

*

Guide.

3

The supplied accessories and the connectors of this unit (USB) are

*

neither waterproof nor dustproof. To reduce the risk of fire or electric
shocks, do not expose the unit to water or droplets while using either
or both of the connectors (USB). Do not place a vase or any other
liquid-filled container on the unit.

The waterproof and dustproof performance of the unit is based on our
measurements under the conditions herein described. Note that
malfunctions as a result of water immersion or dust intrusion caused
by misuse by the customer are not covered by the warranty.

2

as specified in “Degrees of protection against

3

.

with detergent or bath agents, shampoo, hot spring
water, salt water, etc.)

3

, and a dustproof

To avoid the deterioration of waterproof and dustproof
performance

Check the following and use the unit correctly.

• This unit does not have a design that is resistant to water pressure. Use
of the unit in a location where high water pressure is applied, such as
in the shower, may cause a malfunction.

• Do not pour high-temperature water or blow hot air from a hair dryer
or any other appliance on the unit directly. Also never use the unit in a
place subject to high temperatures, such as in a sauna or near a heat
source.

• Handle the cap with care. The cap plays a very important role in
maintenance of the waterproof and dustproof performance. When
using the unit, make sure that the cap is closed completely. When
closing the cap, be careful not to allow foreign objects inside. If the cap
is not closed completely the waterproof and dustproof performance
may deteriorate and may cause a malfunction of the unit as a result of
water or dust particles entering the unit.

Cap

How to care for the unit

You can use the unit more comfortably and for a longer period of time
by following the maintenance procedure below.

• If the surface of the unit gets dirty in the following cases, wash the unit
with fresh water (tap water, etc.) promptly to remove the dirt. Leaving
dirt on its surface may cause the surface to discolor or deteriorate, or
the unit to malfunction.
Ex.

– When the unit has sand, salt (chlorine), or other residue on it after

having been used in a mountain area, by a swimming pool, etc.

– When the unit is stained with foreign substances (sunscreen, suntan

oil, etc.)

• If the unit gets wet, wipe off the moisture using a dry soft cloth
immediately. In addition, dry the unit in an airy place until no moisture
remains.

• The sound quality may change if water enters the speaker component
of the unit. This, however, does not indicate a malfunction. Wipe the
moisture off the unit surface, and leave the unit on a dry soft cloth with
its surface with the speaker component facing down to let the water
out from inside the unit. Then, dry the unit in an airy place until no
moisture remains.

Note

• If the surface of the unit gets dirty, do not use detergent, thinner,
benzine, alcohol, etc. to clean the unit because it will affect the water
repellent function of the unit.

• Especially in cold regions, be sure to wipe off the moisture after using
the unit. Leaving moisture on its surface may cause the unit to freeze
and malfunction.

Notes on the License

This product contains software that Sony uses under a licensing
agreement with the owner of its copyright. We are obligated to
announce the contents of the agreement to customers under
requirement by the owner of copyright for the software.
Please access the following URL and read the contents of the
license.
https://rd1.sony.net/help/speaker/sl/21/

Specifications

Speaker section

Speaker system Approx. 46 mm dia. × 1
Enclosure type Passive radiator model

BLUETOOTH

Communication System

Maximum communication range

Frequency band 2.4 GHz band (2.4000 GHz - 2.4835 GHz)
Modulation method

Compatible BLUETOOTH Profiles*

Supported Codec*

Transmission range (A2DP)

1

The actual range will vary depending on factors such as obstacles

*

between devices, magnetic fields around a microwave oven, static
electricity, reception sensitivity, antenna's performance, operating
system, software application, etc.

2

BLUETOOTH standard profiles indicate the purpose of BLUETOOTH

*

communications between devices.

3

Codec: Audio signal compression and conversion format

*

Note

Depending on the network environment, there may be an interruption at
the high bitrate transmission.

Microphone

Type Electret condenser
Directional characteristic

Effective frequency range

General

Power DC5V 500mA (using the USB power supply) or using

Lithium-ion battery life (with playback via a BLUETOOTH connection)

Dimensions (including projecting parts and controls)

Mass Approx. 253g including battery
Supplied accessory

4

*

Actual performance time may vary from the listed time due to the

volume, songs played, surrounding temperature, and usage
conditions.

5

Measured value acquired by playing our specified music source with

*

the volume level of the unit set to 26.

6

Measured value acquired by playing our specified music source with

*

the volume level of the unit set to the maximum.

7

A charging cable exclusively designed for the unit. Do not use the

*

cable for any other purposes.

System requirements for charging battery using USB

Using a USB power supply capable of feeding in DC 5 V 0.5 A.

Design and specifications are subject to change without notice.

BLUETOOTH Specification version 4.2

Line of sight approx. 10 m*

FHSS

A2DP (Advanced Audio Distribution Profile)
AVRCP (Audio Video Remote Control Profile)
HSP (Headset Profile)
HFP (Hands-free Profile)

3

SBC (Subband Codec)
AAC (Advanced Audio Coding)

1

2

20 Hz - 20 000 Hz (Sampling frequency 44.1 kHz)

Omni directional

100 Hz - 7 000 Hz

built-in lithium-ion battery

4 *5

Approx. 16hours*
Approx. 5 hours*

4 *6

Approx. 76 mm dia. × 95 mm (H)

7

USB Type-C cable (USB-A to USB-C)*
Strap (1) (attached to the unit)

(1),

Disclaimer regarding services offered by third parties

Services offered by third parties may be changed, suspended, or
terminated without prior notice. Sony does not bear any
responsibility in these sorts of situations.