SLV-E325EG/E475EG/E570EE/E570EG/E715B/E717VC/E720B/E720BZ/E720EE/
E720EG/E720EX/E720NC/E720NP/E720UX/E720VC/E720VP/E725NC
RMT-V197/V197A/V197B/V198/V198A/V198J/V198K/V199/V199A
East European Model
Greek Model
SLV-E325EG/E475EG/E570EE/
E570EG/E720EE/E720EG
SERVICE MANUAL
SUPPLEMENT-1
File this supplement with the service manual.
Subject: EEP ROM INITIAL DATA INPUT
1. EEP ROM INITIAL DATA INPUT
When EEP ROM (IC472 on FR-119 board) was changed, make it
sure to input the data shown below and to perform “2-3-1. RF
Switching Position Adjustment” .
French Model
SLV-E715B/E720B/E720BZ
Irish Model
SLV-E720EX
North European Model
SLV-E720NC/E725NC
Spanish Model
SLV-E720NP
UK Model
SLV-E720UX
German Model
SLV-E717VC/E720VC
(99-018)
Austrian Model
German Model
SLV-E720VP
5) Turn off the power
6) Disconnect the adjusting remote commander and LANC jig
from the connector (CN164).
Input Method:
1) Connect the LANC jig (J-6090-051-A) to CN164 on MA-286
board.
2) Turn on the power.
3) Input Data: 80 in Address: 00 on Page: 1.
4) Input data on Page F as following table.
Page
Address
SLV-E325EG
02
02
SLV-E720BZ
Data
F
930201
00
2504SLV-E715B
00
2001SLV-E717VC
00
250502
70
60
70
B6B594
106001200004
106001200104SLV-E475EG
106001200204SLV-E570EE
106001200304SLV-E570EG
10
10
107000250402SLV-E720B
10
106001200404SLV-E720EE
106001200504SLV-E720EG
107000240103SLV-E720EX
107000200202SLV-E720NC
107000200302SLV-E720NP
107000240003SLV-E720UX
106000200102SLV-E720VC
106000200002SLV-E720VP
107000200202SLV-E725NC
Sony Corporation
9-921-624-81
Home Video Company
Note: When connecting or disconnecting LANC jig to CN164 on
MA-286 board, first connect the adjusting remote commander (J-6082-053-B) to the jack on LANC jig before
connecting LANC jig to CN164. Connection or disconnection of the adjusting remote commander in the condition LANC jig is connected to CN164 causes IC LINK
(PS001) to damage itself.
99I0564-1
Printed in Japan © 1999. 9
Published by Quality Assurance Dept.