Sony M-437, M-579V, M-529V, M-427C, M-427 User Manual 2

...
0 (0)
Precautions
Troubleshooting
Maintenance
3-858-067-81(1)
On power
•Operate the unit only on 3 V DC. For AC operation, use the AC adaptor recommended for the unit. Do not use any other type. For battery operation, use two R6 (size AA) batteries.
On the unit
•Use only the y (standard microcassettes) with this unit. Non-standard cassettes cannot be used because their “L” dimension (see illustration) is different.
Standard
Only standard microcassettes have a small indention of side A.
Approx. 5 mm
•Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock.
•Should any solid object or liquid fall into the unit, remove the batteries or disconnect the AC power adaptor, and have the unit checked by qualified personnel before operating it any further.
•Keep personal credit cards using magnetic coding or spring-wound watches etc. away from the unit to prevent possible damage from the magnet used for the speaker.
•When you do not use the unit for long, remove the batteries to avoid damage caused by battery leakage and subsequent corrosion.
•If the unit has not been used for long, set it in the playback mode and warm it up for a few minutes before inserting a cassette.
If you have any questions or problems concerning your unit, please consult your nearest Sony dealer.
Non-standard
Approx. 2.5 mm
Should any problem persist after you have made these checks, consult your nearest Sony dealer.
A cassette cannot be inserted.
n The cassette is being inserted in the wrong way.
(The cassette should be inserted in the lid with the tape side facing you.)
n 9 has been already pressed.
r cannot be pressed.
n There is no cassette in the cassette compartment. n The cassette tab has been removed.
r or 9 cannot be pressed.
n The tape has reached the end. n After the automatic shut-off, CPAUSE is slid in
the direction of the arrow.
The unit does not operate.
n The batteries have been inserted with incorrect
polarity.
n The batteries are weak. Replace both batteries with
new ones.
nCPAUSE is slid in the direction of the arrow. n The AC power adaptor or car battery cord is
connected to the unit only and you are going to use the unit on batteries.
No sound comes from the speaker.
n The earphone is plugged in. n The volume is turned down completely.
The sound drops out or comes with excessive noise.
n The volume is turned down completely. n The batteries are weak. Replace both batteries with
new ones.
n The head is contaminated. See “Maintenance”.
Tape speed is too fast or too slow in the playback mode.
n Improper setting of the TAPE SPEED switch. Set it
to the same speed as that used for recording.
Tape speed is faster than the normal playback speed.
n The TAPE SPEED switch is set between the 1.2 cm
and 2.4 cm positions.
Recording cannot be made.
n Connection is made incorrectly. n The batteries are weak. Replace both batteries with
new ones.
n The head is contaminated. n Improper setting of the VOR switch (M-529V/
539V/579V only). Set it to H or OFF.
Recording is interrupted.
n The VOR switch (M-529V/539V/579V only) is set
to H or L. When you do not use VOR, set it to OFF.
Recording cannot be erased completely.
n The head is contaminated.
Capstan
Pinch roller
To clean the tape head and path
Press 9 and wipe the head, capstan and the pinch roller with a cotton swab, moistened with alcohol every 10 hours of use.
To clean the exterior
Use a soft cloth slightly moistened in water. Do not use alcohol, benzine or thinner.
Head
Specifications
Tape
y (normal position type)
Recording system
2-track 1-channel monaural
Speaker
Approx. 3.6 cm (17⁄16 in.) dia.
Tape speed
2.4 cm/s (15⁄16 ips), 1.2 cm/s (15⁄32 ips)
Frequency range
300 – 4,000 Hz
Output
Earphone jack (minijack) for 8 – 300 ohms earphone
Power output (at 10% harmonic distortion)
160 mW
Battery life (recording)
See “Preparing Power Souces”.
Power requirements
3 V DC Two R6 (size AA) batteries
Dimensions (w/h/d)
Approx. 66.7 x 120.8 x 25 mm (23⁄4 x 47⁄8 x 1 in.) incl. projecting parts and controls
Mass
Approx. 160 g (5.7 oz) incl. batteries
Design and specifications are subject to change without notice.
Optional accessories
Microcassette MC-60, MC-30 Earphone ME-81, ME-L82 Connecting cord RK-G64HG (miniplug to miniplug with attenuator) AC power adaptor AC-E30HG Car battery cord DCC-E130L
Operating Instructions
M-417/427/427C/437/
529V/539V/579V
Sony Corporation ©1997 Printed in Japan
WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture.
Welcome!
Thank you for purchasing the Sony Microcassette­Corder. Some features are:
•The BATT lamp indicates when to replace the batteries.
•The VOR (Voice Operated Recording) system (M-529V/ 539V/579V only) starts and stops recording automatically in response to the sound.
•Edit function—You can start recording directly from the playback mode by pressing the r button to correct a previously recorded portion.
•Tape counter (M-529V/539V/579V only)
•Automatic shut-off mechanism at the end of the tape (in the recording/playback mode only)
•Stop-pause-release function—The pause switch is released automatically when the p6 button is depressed, so that you don’t miss a recording chance.
Loading...
+ 1 hidden pages