Sony LSPXA1R User Manual
GB
WARNING
To reduce the risk of fire or electric
shock, do not expose this
apparatus to rain or moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing to
qualified personnel only.
WARNING
THIS APPARATUS MUST BE EARTHED.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
When you dispose of the battery, you must obey the
law in the relative area or country.
WARNING
When installing the unit, incorporate a readily accessible
disconnect device in the fixed wiring, or connect the
power plug to an easily accessible socket-outlet near
the unit.
If a fault should occur during operation of the unit,
operate the disconnect device to switch the power
supply off, or disconnect the power plug.
CAUTION
About the LAN connector
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port.
WARNING
1. Use the approved Power Cord (3-core mains lead) /
Appliance Connector / Plug with earthing-contacts
that conforms to the safety regulations of each
country if applicable.
2. Use the Power Cord (3-core mains lead) / Appliance
Connector / Plug conforming to the proper ratings
(Voltage, Ampere).
If you have questions on the use of the above Power
Cord / Appliance Connector / Plug, please consult a
qualified service personnel.
Caution
Two size AAA (R03) batteries are required for Remote
Control.
To avoid risk of explosion, use size AAA (R03)
manganese or alkaline batteries.
For the customers in the U.S.A.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
All interface cables used to connect peripherals must be
shielded in order to comply with the limits for a digital
device pursuant to Subpart B of part 15 of FCC Rules.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
If you have any questions about this product, you may
call;
Sony Customer Information Service Center
1-800-222-7669 or http://www.sony.com/
GB
3
Sony LSPX-A1 4-732-088-11(1)Sony LSPX-A1 4-732-088-11(1)
Declaration of Conformity
Trade Name: SONY
Model: LSPX-A1
Responsible party: Sony Electronics Inc.
Address: 16535 Via Esprillo, San Diego, CA
92127 U.S.A.
Telephone Number: 858-942-2230
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2)this device must accept any interference
received, including interference that may cause
undesired operation.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
For the customers the U.S.A. and Canada
Radiated Exposure Statement:
This equipment complies with FCC/IC radiation
exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF)
Exposure Guidelines and RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment has very
low levels of RF energy that is deemed to comply
without maximum permissive exposure evaluation
(MPE).
For the customers in Canada
This device complies with Industry Canada’s licenceexempt RSSs. Operation is subject to the following two
conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of
the device.
For the customers the U.S.A. and Canada
CAUTION
Use of controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
This product is classified as a CLASS 2 LASER PRODUCT.
WARNING
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
CAUTION
Do not look into the lens while in use.
CAUTION
Do not allow children to operate this product without
supervision.
CAUTION
The use of optical instruments with this product will
increase eye hazard.
For the customers in other countries
IEC 60825-1:2014
CLASS 1 LASER PRODUCT
As with any bright light source,
do not stare into the beam,
RG2 IEC 62471-5:2015.
Carrying the
projector
Only lift the projector with four or more people, one
person at each corner. Firmly grasp the handles located
at the bottom of the projector with both hands.
Notes
• The projector is heavy. Grasp it firmly when moving it to
avoid dropping it and causing injuries.
• It may be difficult to see the ground when carrying the
projector. Note the following to avoid injury.
– Do not step on the AC power cord or cables from the
– Do not get caught in the AC power cord or cables from the
– Do not set the projector down on your feet.
• Do not subject the projector to strong impacts when moving
it. It may drop or break, resulting in serious injuries.
• Use the box and packing materials that originally contained
the projector when it needs to be carried for repairs or
moving.
For the customers in Canada
CAN ICES-3 (B)/NMB-3(B)
CAUTION
When you connect the LAN cable of the unit to
peripheral device, use a shielded-type cable to prevent
malfunction due to radiation noise.
GB
4
CAUTION
Use of controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
CAUTION
Do not look into the lens while in use.
CAUTION
The use of optical instruments with this product will
increase eye hazard.
Loading...