Sony FD Trinitron KV-24LS35U Instruction Manual
R
4-206-159- 31 (1)
FD Trinitron
Colour Television
KV-24LS35U
© 2001 by Sony Corporation
Instruction Manual
GB
01Cover24LS35U.fm Page 1 Friday, September 21, 2001 12:20 PM
Ofrecido por www.electromanuales.com
2
NOTICE FOR CUSTOMERS IN THE UNITED KINGDOM
A moulded plug complying with BS1363 is fitted to this equipment for your safety and
convenience.
Should the fuse in the plug supplied need to be replaced, a 5 AMP fuse approved by ASTA or
BSI to BS 1362 (i.e. marked with 2 or @ ) must be used.
When an alternative type of plug is used it should be fitted with a 5 AMP FUSE, otherwise the
circuit should be protected by a 5 AMP FUSE at the distribution board.
If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse
cover after you change the fuse. Never use the plug without the fuse cover. If you should lose
the fuse cover, please contact your nearest Sony service centre.
How to replace the fuse
Open the fuse compartment with a blade screwdriver, and replace the fuse.
•
IMPORTANT
If the plug supplied is not suitable for the socket outlets in your home, it should be cut off and
an appropriate plug fitted in accordance with the following instructions:
The wires in this mains lead are coloured in accordance with the following code:
Blue Neutral
Brown Live
As the colours of the wires in the mains lead of this apparatus may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked with the
letter N or coloured black. The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red. Do not connect either wire to the
earth terminal in the plug which is marked by the letter E or by the safety earth symbol
or coloured green or green and yellow.
WARNING
• To prevent shock hazard, do not insert the plug cut off from the mains lead into a socket
outlet. This plug cannot be used and should be destroyed.
• To prevent fire or shock hazard, do not expose the unit to rain or moisture.
• Dangerously high voltages are present inside the set. Do not open the cabinet. Refer servicing
to qualified personnel only.
02p2KV24LS35U.fm Page 2 Friday, September 21, 2001 12:22 PM
Ofrecido por www.electromanuales.com
3
GB
Introduction
Thank you for choosing this Sony FD Trinitron Colour Television.
Before operating the TV, please read this manual thoroughly and retain it for future
reference.
• Symbols used in the manual:
Table of Contents
Notice for Customers in the United Kingdom....................................................................................2
Introduction.............................................................................................................................................. 3
Safety Information................................................................................................................................... 4
Overview
Overview of Remote Control Buttons .................................................................................................. 5
Overview of TV Buttons ........................................................................................................................6
Installation
Inserting Batteries into the Remote Control ........................................................................................ 6
Connecting the Aerial and VCR ...........................................................................................................6
First Time Operation
Switching On the TV and Automatically Tuning ..............................................................................7
Menu system
Introducing and Using the Menu System............................................................................................ 9
Menu Guide:
Picture Adjustment .............................................................................................................................9
Sound Adjustment............................................................................................................................. 10
Sleep Timer.........................................................................................................................................11
On Timer............................................................................................................................................. 11
Language ............................................................................................................................................11
Auto Tuning ....................................................................................................................................... 12
Programme Sorting ...........................................................................................................................12
Programme Labels............................................................................................................................. 12
AV Preset ............................................................................................................................................12
Manual Programme Preset............................................................................................................... 13
Auto Format .......................................................................................................................................15
Noise Reduction................................................................................................................................. 15
AV2 Output ........................................................................................................................................ 16
RGB Centring .....................................................................................................................................16
Picture Rotation .................................................................................................................................16
Teletext
...............................................................................................................................................17
Additional Information
Connecting Optional Equipment ........................................................................................................18
Using Optional Equipment .................................................................................................................. 19
Remote Control Configuration for VCR/DVD................................................................................. 20
Specifications.......................................................................................................................................... 21
Troubleshooting..................................................................................................................................... 22
Television Channel Guide for United Kingdom............................................................................... 23
• Informs you of possible hazards.
• Important information
• Information on a feature.
• 1,2... Sequence of instructions.
• Shaded buttons on the remote control
show you the buttons you have to press
to follow the sequence of the
instructions.
• Informs you of the result of instructions.
OK
Table of Contents
03GBKV24LS35U.fm Page 3 Friday, September 21, 2001 12:23 PM
Ofrecido por www.electromanuales.com
4
Safety Information
Do not open the cabinet and the rear
cover of the TV. Refer to qualified
service personnel only.
To prevent fire or shock
hazard, do not expose the TV
to rain or moisture.
For your own safety, do not touch
any part of the TV, power lead or
aerial lead during lightning
storms.
Do not cover the ventilation
openings of the TV For
ventilation, leave a space of at
least 10cm all around the set.
Never place the TV in hot, humid
or excessively dusty places. Do
not install the TV where it may be
exposed to mechanical vibrations.
To prevent fire, keep inflammable
objects or naked lights (eg
candles) away from the TV.
Clean the TV with a soft, lightly
dampened cloth. Do not use
benzine, thinner or any other
chemicals to clean the TV. Do not
scratch the TV screen. As a safety
precaution, unplug the TV before
cleaning it.
Pull out the power lead by the
plug. Do not pull on the power
lead itself.
Take care not to place heavy
objects on the power lead as this
could result in damage.
We recommend you wind any
excess lead around the holders
provided on the rear of the TV.
Place the TV on a secure stable
stand. Do not allow children to
climb on to it. Do not place the TV
on its side or face up.
Do not cover the ventilation
openings of the TV with items
such as curtains or newspapers
etc.
Safety Information
Never push objects of any kind into
the set as this could result in a fire
or electric shock. Never spill liquid
of any kind on the set. If any liquid
or solid object does fall through, do
not operate the TV. Have it checked
immediately by qualified
personnel.
For environmental and safety
reasons, it is recommended that
the TV set is not left in standby
mode when not in use. Disconnect
from the mains.
This set is to operate on a 220240V AC supply only. Take care
not to connect too many
appliances to the same power
socket as this could result in fire
or electric shock.
Unplug the power lead before
moving the TV. Avoid uneven
surfaces, quick steps or excessive
force. If the set has been dropped
or damaged, have it checked
immediately by qualified service
personnel.
03GBKV24LS35U.fm Page 4 Friday, September 21, 2001 12:23 PM
Ofrecido por www.electromanuales.com
5
GB
Overview of Remote Control Buttons
Overview
Besides TV functions, all coloured buttons as well as green symbols are also used for
Teletext operation. For more details, please refer to “Teletext” section of this instruction
manual.
VCR or DVD on/off
Press to switch your VCR or DVD on or
off.
Selecting channels
If Media Selector is switched on TV or
VCR, press to select channels.
For double-digit programme numbers,
enter the second digit within 2.5 seconds.
Displaying on Screen information
Press to display all on-screen indications.
Press again to cancel.
Selecting Picture mode
Press repeatedly to change the
picture mode.
Selecting sound mode
Press repeatedly to change the
sound mode.
This button only works in Teletext mode.
Selecting TV mode
Press to switch off teletext or video input.
a) If Media Selector is switched
on TV:
• When MENU is switched on, use these
buttons to operate the menu system.
For details refer to “Introducing and
Using the Menu System” on page 9.
• When MENU is switched off, press OK
to show a channel overview. Then
press
or to select the channel
and then press again the OK button to
watch the selected channel.
b) If Media Selector button is
switched on VCR or DVD:
Using these buttons you can control the
main functions of your VCR or DVD.
Displaying the menu system
Press to display the menu on the TV
screen. Press again to remove the menu
display from the TV screen.
Adjusting TV volume
Press to adjust the volume of the TV.
Muting the Sound
Press to mute TV sound. Press again to
restore the sound.
To Temporarily Switch Off TV
Press to temporarily switch off TV (the standby
indicator on TV lights up). Press again to switch on
TV from standby mode.
To save energy we recommend
switching off completely when TV is not
in use.
After 15 minutes without a signal
and without any button being
pressed, the TV switches
automatically into standby mode.
Selecting input source
Press repeatedly until the desired
input symbol of the source appears on
the TV screen.
a) If Media Selector button is
switched on TV:
Press to watch the last channel selected
(watched for at least 5 seconds).
b) If Media Selector button is
switched on VCR:
For Sony’s VCR double-digit
programme numbers, e.g. 23, press
-/- - first and then the buttons 2
and 3.
Selecting Screen format
Press repeatedly to change the
format of the screen. For more
details, refer to chapter “Auto
Format” on page 15.
Selecting Teletext
Press to switch on teletext.
Recording button
If Media Selector is switched on VCR,
press this button to record
programmes.
Media Selector
With this remote control you can
operate not only this TV but also the
main functions of your VCR or DVD.
Switch on the device you want to
operate and next press this button
repeatedly to select the VCR, TV or
DVD. A green light will be lit
momentarily.
An initial set up is required to
synchronise this remote control to
your VCR or DVD. It will depend on the
Brand of those products. For more
details, refer to chapter “Remote
Control Configuration for VCR or
DVD” on page 20.
Selecting channels
Press to select the next or previous
channel.
03GBKV24LS35U.fm Page 5 Friday, September 21, 2001 12:23 PM
Ofrecido por www.electromanuales.com
6
Overview of TV Buttons
Inserting Batteries into the Remote Control
Make sure you insert the supplied batteries using the correct polarities.
Always remember to dispose of used batteries in an environmental friendly way.
Connecting the Aerial and VCR
On/Off switch
Standby
indicator
Programme Up or
Down Buttons (Selects
TV channels)
Selecting
Input source
Volume control
buttons
Auto Start
Up Button
Press on the mark on
the door flap to reveal the
control panel.
Video
Input jack
Audio
Input
jacks
Headphones
jack
S Video
Input
jack
Overview-Installation
or
VCR
Scart lead is optional.
For more details of VCR connection, please
refer to the section “Connecting Optional
Equipment” of this instruction manual.
OUT IN
Connecting cables are not supplied.
03GBKV24LS35U.fm Page 6 Friday, September 21, 2001 12:23 PM
Ofrecido por www.electromanuales.com
7
GB
Language
Select Language:
i
4
Svenska
Norsk
English
Nederlands
Français
Italiano
i
$
OK
If picture slants, please
adjust picture rotation
Not necessary
Adjust now
OK
OK
OK
Switching On the TV and Automatically Tuning
The first time you switch on your TV, a sequence of menu screens appear on the TV enabling you to: 1) choose the language of the menu screen, 2) adjust the picture slant 3) search
and store all available broadcast channels and 4) change the order in which the broadcast
channels appear on the screen.
However, if you need to change any of these settings at a later date, you can do that by
selecting the appropriate option in the (Set Up menu) or by pressing the Auto Start Up
Button on the TV set.
First Time Operation
continued...
1
Connect the TV plug to the mains socket (220-240V AC,
50Hz)
The first time the TV set is connected, it is usually turned
on. If the TV is off, press the on/off button on the TV
set to turn on the TV.
The first time you switch on the TV, a Language menu
displays automatically on the TV screen.
2
Press the or button on the remote control to select
the language, then press the OK button to confirm your
selection. From now on all the menus will appear in the
selected language.
3
Because of the earth’s magnetism, the picture might slant.
The Picture Rotation menu allows you to correct the
picture slants if it is necessary.
a)
If it is not necessary, press or to select Not
necessary and press OK .
b)
If it is necessary, press or to select Adjust now ,
then press OK and correct any slant of the picture
between –5 and +5 by pressing or . Finally press
OK
to store.
03GBKV24LS35U.fm Page 7 Friday, September 21, 2001 12:23 PM
Ofrecido por www.electromanuales.com
8
MENU
First Time Operation
Your TV is now ready for use
4
The Auto Tuning menu appears on the screen. Press the
OK button to select Yes .
5
The TV starts to automatically search and store all
available broadcast channels for you.
This procedure could take some minutes. Please be
patient and do not press any buttons, otherwise the
automatic tuning will not be completed.
If no channels were found during the auto tuning
process then a new menu appears automatically on
the screen asking you to connect the aerial. Please
connect the aerial (see page 6) and press OK . The
auto tuning process will start again.
6
After all available broadcast channels are captured
and stored, the Programme Sorting menu appears
automatically on the screen enabling you to change
the order in which the broadcast channels appear on
the screen.
a)
If you wish to keep the broadcast channels in the
tuned order, go to step 7.
b)
If you wish to store the broadcast channels in a
different order:
1
Press the or button to select the programme
number with the broadcast channel you wish
to rearrange, then press the button.
2
Press the or button to select the new
programme number position for your selected
broadcast channel, then press .
3
Repeat steps b)1 and b)2 if you wish to change
the order of the other broadcast channels.
7
Press the MENU button to remove the menu from the
screen.
No channel found
Please connect aerial
Confirm
OK
Programme: 01
Channel: C21
Auto Tuning
Searching...
Programme Sorting
Select channel:
Exit:
MENU
Programme:
01 TVE
02 TVE2
03 TV3
04 C33
05 C27
06 C58
OK
Programme Sorting
Select new position:
Exit: MENU
Programme:
01 TVE
02 TVE2
03 TV3
04 C33
05 C27
06 C58 05 C27
OK
Do you want to start
automatic tuning?
Yes
No
OK
OK
OK
OK
OK
#
)
0
3
p
P
·
03GBKV24LS35U.fm Page 8 Friday, September 21, 2001 12:23 PM
Ofrecido por www.electromanuales.com
Loading...