Sony DVP-SR750HP Users guide

CD/DVD Player
4-266-026-11(1)
Reference Guide
DVP-SR750HP
© 2011 Sony Corporation

WARNING

To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. The mains lead must be changed only at a qualified service shop. Batteries or batteries installed apparatus shall not be exposed to excessive heat such as sunshine, fire or the like.
This appliance is classified as a CLASS 1 LASER product. The CLASS 1 LASER PRODUCT MARKING is located on the rear exterior.
CAUTION
The use of optical instruments with this product will increase eye hazard. As the laser beam used in this CD/DVD player is harmful to eyes, do not attempt to disassemble the cabinet. Refer servicing to qualified personnel only.
Precautions
• To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus.
• The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off.
• Do not install this player in a confined space, such as a bookshelf or similar unit.
• Install the player so that the AC power cord (mains lead) can be unplugged from the wall socket immediately in the event of trouble.
• If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the player. Should
2
this occur, the player may not operate properly. In this case, remove the disc and leave the player turned on for about half an hour until the moisture evaporates.
Lightning
For added protection for this set during a lightning storm, o r when it is left unattended and unused for long periods of time, unplug it from the wall outlet. This will prevent damage to the set due to lightning and power-line surges.
Note about the discs
Do not use the following discs: – A disc that has a non-standard
shape (e.g., card, heart).
– A disc with a label or sticker on
it.
Region code
Your player has a region code printed on the back of the unit and only will play commercial DVDs (playback only) labelled with identical region codes. This system is used to protect copyrights.
Commercial DVDs labelled will also play on this player.
Depending on the commercial DVD, there may be no region code indication, even though playing the commercial DVD is prohibited by area restrictions.
DVP–XXXX
00V 00Hz
NO.
X
00W
0-000-000-00
Copyrights
• Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories.
• “DVD+RW,” “DVD-RW,” “DVD+R,” “DVD+R DL,” “DVD-R,” “DVD VIDEO,” and “CD” logos are trademarks.
• MPEG Layer-3 audio coding technology and patents licensed from Fraunhofer IIS and Thomson.
• This DVD player incorporates High-Definition Multimedia Interface (HDMI™) technology. HDMI, the HDMI Logo, and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI
ALL
Region code
Licensing LLC in the United States and other countries.
• All other trademarks are trademarks of their respective owners.
• THIS PRODUCT IS LICENSED UNDER THE MPEG-4 VISUAL PATENT PORTFOLIO LICENSE FOR THE PERSONAL AND NONCOMMERCIAL USE OF A CONSUMER FOR DECODING VIDEO IN COMPLIANCE WITH THE MPEG-4 VISUAL STANDARD (“MPEG-4 VIDEO”) THAT WAS ENCODED BY A CONSUMER ENGAGED IN A PERSONAL AND NONCOMMERCIAL ACTIVITY AND/OR WAS OBTAINED FROM A VIDEO PROVIDER LICENSED BY MPEG LA TO PROVIDE MPEG-4 VIDEO. NO LICENSE IS GRANTED OR SHALL BE IMPLIED FOR ANY OTHER USE. ADDITIONAL INFORMATION INCLUDING THAT RELATING TO PROMOTIONAL, INTERNAL AND COMMERCIAL USES AND LICENSING MAY BE OBTAINED FROM MPEG LA, LLC. SEE HTTP://WWW.MPEGLA.COM
About this manual
“DVD” may be used as a general term for commercial DVDs, DVD+RWs/DVD+Rs/DVD+R DLs (+VR mode) and DVD-RWs/ DVD-Rs/DVD-R DLs (VR mode, video mode).

Playback

Control Menu display

Use the Control Menu to select a function and to view related information.
Press DISPLAY.
To change the Control Menu display, press DISPLAY again.
)
1 2 ( 2 7
)
1 8 ( 3 4 T
1 : 3 2 : 5 5
OFF OFF SET ON
PROGRAM
ENTER DISPLAY
A Control Menu items B Currently playing title/Total number of
titles
C Currently playing chapter/Total number
of chapters
D Playing time E Selected media type F Playback status G Selected item icon/menu options H Operation message I Selected Control Menu item

Menu list

Item Item Name, Function
TITLE/SCENE/TRACK
CHAPTER/INDEX
TRACK
Selects the title, scene, track, chapter, or index to be played.
Quit:
PLAY DVD VIDEO
TIME/TEXT
Checks the elapsed time and the remaining playback time. Input the time code for picture and music search (DVD and Xvid video files only).
DISC/USB
Selects either “USB” or “DISC” to be played.
TOP MENU/MENU
(DVD VIDEO only)
TOP MENU: Displays the top menu. MENU: Displays the menu.
REC TO USB
Rips a CD, or copies photo, music and video files to a USB device (page 6).
ORIGINAL/PLAY LIST
Selects the type of title (DVD-VR mode) to be played: ORIGINAL, or edited PLAY LIST.
PROGRAM*
1, *2
Selects the title, chapter, or track to play in the order you want.
1 Select “SET t,” then press ENTER and
select the title (T), chapter (C), or track (T) you want to programme, and press ENTER.
2 Repeat selecting the title, chapter, or track. 3 Press N.
SHUFFLE*
1, *2
Plays the title, chapter, or track in random order.
REPEAT*
1, *2
Plays all titles/tracks/albums or a single title/ chapter/track/album/file repeatedly.
A-B REPEAT*
1, *2
Specifies the parts you want to play repeatedly. 1 During playback, select “SET t,” then
press ENTER. The “A-B REPEAT” setting bar appears.
2 When you find the starting point (point A),
press ENTER.
3 When you reach the ending point (point B),
press ENTER again.
PARENTAL CONTROL
Set to prohibit playback on this player. PLAYER t: Playback of some DVD VIDEOs can be limited according to a predetermined level such as the age of the users. Scenes may be blocked or replaced with different scenes (Parental Control).
,continued
3
PASSWORD t: Enter a 4-digit password using the number buttons. Also use this menu to change the password.
Parental Control (limited playback)
You can set a playback limitation level. 1 Select “PLAYER t,” then press ENTER.
Enter or re-enter your 4-digit password, then press ENTER.
2 Press X/x to select “STANDARD,” then
press ENTER. Press X/x to select an area, then press ENTER. When you select “OTHERS t,” select and enter a standard code. See “PARENTAL CONTROL AREA CODE LIST” at the end of this manual.
3 Press X/x to select “LEVEL,” then press
ENTER. Press X/x to select the level, then press ENTER. Parental Control setting is complete. The lower the value, the stricter the limitation. To turn off the Parental Control function, set
“LEVEL” to “OFF.” If you forget your password, enter “199703” in the password box, press ENTER, and then enter a new 4-digit password.
SETUP
QUICK: Use Quick Setup t o choose the desired language of the on-screen display, the aspect ratio of the TV and the audio output signal.
CUSTOM: In addition to the Quick Setup setting, you can adjust various other settings (page 7).
RESET: Returns the settings in “SETUP” to the default setting.
1
ZOOM*
Magnifies the image up to four times the original size, scroll using C/X/x/c.
ANGLE
Changes the angle.
CUSTOM PICTURE MODE
Selects the picture quality that best suits the programme you are watching.
STANDARD: Displays a standard picture. DYNAMIC: Produces a bold dynamic picture
by increasing the picture contrast and the colour intensity. CINEMA: Enhances details in dark areas by increasing the black level. MEMORY t: Adjusts the picture in greater detail.
SHARPNESS
Exaggerates the outline of the image to produce a sharper picture.
OFF: Cancels this option. 1: Enhances the outline. 2: Enhances the outline more than 1.
AV SYNC
Adjust the delay between the picture and sound. This function is not effective when: – you use the DIGITAL OUT (COAXIAL)
jack, and set “DOLBY DIGITAL,” “MPEG,” or “DTS” in “AUDIO SETUP” to “DOLBY DIGITAL,” “MPEG,” or “ON” respectively (page 7).
– you connect a Dolby Digital or DTS-
compliant device via the HDMI OUT jack, and set “DOLBY DIGITAL,” “MPEG,” or “DTS” in “AUDIO SETUP” to “DOLBY DIGITAL,” “MPEG,” or “ON” respectively (page 7).
1 Select “SET t,” then press ENTER.
The “AV SYNC” adjustment bar appears.
2 Press c repeatedly to adjust the delay.
Each time you press C/c, the delay is adjusted by 10 milliseconds.
3 Press ENTER.
The selected setting takes effect. To reset the “AV SYNC” setting, press CLEAR in step 2.
*1To return to normal play, select “OFF” or press
CLEAR.
2
The play mode is cancelled when:
*
– you open the disc tray. – you turn off the player.
Items for DATA discs or USB
Item Item Name, Function
ALBUM
Selects the album that contains music and photo files to be played.
FILE
Selects the photo file to be played.
ALBUM
Selects the album that contains the video file to be played.
FILE
Selects the video file to be played.
DATE
Displays the date the picture was taken by a digital camera.
4
INTERVAL*
Specifies the duration for which the slides are displayed on the screen.
EFFECT*
Selects the effects to be used for changing slides during a slide show. MODE 1: The images randomly cycle through the effects. MODE 2: The image sweeps in from top left to bottom right. MODE 3: The image sweeps in from top to bottom. MODE 4: The image sweeps in from left to right. MODE 5: The image stretches out from the centre of the screen. OFF: Turns off this function.
MEDIA
Selects the media type you want to play.
VIDEO: Plays video files. PHOTO (MUSIC): Plays photo and music
files as a slide show. You can view a slide show with sound when music and photo files are placed in the same album. If the playing time of either music or photos is longer, the longer one continues without sound or image. PHOTO (BGM): Plays photo files with the player’s internal background sound. To choose the melody of the background sound, press AUDIO repeatedly while viewing the image. MUSIC: Plays music files. Press SUBTITLE while playing music files that contain unsynchronized lyric information. The player supports MP3 ID3 Lyrics only.
* Depending on the file, this function may not be
possible.

To change the colour system

If the on-screen menu of the player does not appear on the connected TV, switch the player’s colour system to match the colour system of the TV (NTSC or PAL). First turn off the player by pressing [/1. Next press DISPLAY, enter “0” using the number button, and then press [/1 on the remote. The player turns back on, and the name of the colour system will appear on the front panel display.

To play VIDEO CDs with PBC functions

When you start playing a VIDEO CD with PBC (Playback control) functions, the menu for your selection appears.
To play without using PBC
Press ./> or the number buttons while the player is stopped to select a track, then press N or ENTER. To return to PBC playback, press x twice, then press N.

To lock the disc tray (Child Lock)

You can lock the disc tray to prevent it being opened by mistake. When the player is in standby mode, press in order, O RETURN, ENTER, and [/1 on the remote. The player turns on and “ ” (LOCKED) appears on the front panel display. The Z button does not work while the Child Lock is set.
To unlock the disc tray
When the player is in standby mode, press in order, O RETURN, ENTER, and \/1 on the remote again.

Controlling TVs with the remote

You can control the sound level, input source, and power switch of your Sony TV with the supplied remote. If your TV is listed in the table below, set the appropriate manufacturer’s code. When you replace the batteries of the remote, set the appropriate code number again.
1 While holding down TV [/1, press the
number buttons to select your TV’s manufacturer’s code.
2 Release TV [/1.
Code numbers of controllable TVs
Sony 01 (default) Hitachi 24 JVC 33 LG/Goldstar 76 Panasonic 17, 49 Philips 06, 08, 72 Samsung 71 Sharp 29 Toshiba 38
,continued
5
+ 11 hidden pages