Sony DVP-SR210P User Manual

CD/DVD Player

4-400-834-11(1)

Reference Guide

DVP-SR210P

© 2012 Sony Corporation

WARNING

To reduce the risk of fire or
electric shock, do not expose
this apparatus to rain or
moisture.
To avoid electrical shock, do
not open the cabinet. Refer
servicing to qualified
personnel only.
The AC power cord must be
changed only at a qualified
service shop.
Batteries or batteries
installed apparatus shall not
be exposed to excessive heat
such as sunshine, fire or the
like.

CAUTION

The use of optical instruments with
this product will increase eye
hazard. As the laser beam used in
this CD/DVD player is harmful to
eyes, do not attempt to disassemble
the cabinet.
Refer servicing to qualified
personnel only.

This symbol is
intended to alert the
user to the presence
of uninsulated

within the product’s enclosure that
may be of sufficient magnitude to
constitute a risk of electric shock to
persons.

maintenance (servicing)
instructions in the literature
accompanying the appliance.

Precautions

• To prevent fire or shock hazard,
do not place objects filled with
liquids, such as vases, on the
apparatus.

• The player is not disconnected
from the AC power source as
long as it is connected to the wall

“dangerous voltage”

This symbol is
intended to alert the
user to the presence
of important
operating and

outlet, even if the player itself
has been turned off.

• Do not install this player in a
confined space, such as a
bookshelf or similar unit.

• Install the player so that the AC
power cord can be unplugged
from the wall socket
immediately in the event of
trouble.

• If the player is brought directly
from a cold to a warm location,
or is placed in a very damp room,
moisture may condense on the
lenses inside the player. Should
this occur, the player may not
operate properly. In this case,
remove the disc and leave the
player turned on for about half an
hour until the moisture
evaporates.

For customers in the U.S.A
Owner’s Record

The model and serial numbers are
located at the rear of the unit.
Record the serial number in the
space provided below. Refer to
them whenever you call upon your
Sony dealer regarding this product.

Model No. DVP-SR210P
Serial No.______________

CAUTION

You are cautioned that any
changes or modifications not
expressly approved in this manual
could void your authority to
operate this equipment.

b

This equipment has been tested
and found to comply with the
limits for a Class B digital device,
pursuant to Part 15 of the FCC
Rules. These limits are de signed to
provide reasonable protection
against harmful interference in a
residential installation. This
equipment generates, uses, and can
radiate radio frequency energy
and, if not installed and used in
accordance with the instructions,
may cause harmful interference to
radio communications. However,
there is no guarantee that
interference will not occur in a
particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be
determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:

– Reorient or relocate the

receiving antenna.

– Increase the separation between

the equipment and receiver.

– Connect the equipment into an

outlet on a circuit different from
that to which the receiver is
connected.

– Consult the dealer or an

experienced radio/TV technician
for help.

Important Safety
Instructions

1) Read these instructions.

2) Keep these instructions.

3) Heed all warnings.

4) Follow all instructions.

5) Do not use this apparatus near
water.

6) Clean only with dry cloth.

7) Do not block any ventilation
openings. Install in accordance
with the manufacturer’s
instructions.

8) Do not install near any heat
sources such as radiators, heat
registers, stoves, or other
apparatus (including
amplifiers) that produce heat.

9) Do not defeat the safety
purpose of the polarized or
grounding-type plug. A
polarized plug has two blades
with one wider than the other.
A grounding type plug has two
blades and a third grounding
prong. The wide blade or the
third prong are provided for
your safety. If the provided
plug does not fit into your
outlet, consult an electrician for
replacement of the obsolete
outlet.

10)Protect the power cord from
being walked on or pinched
particularly at plugs,
convenience receptacles, and
the point where they exit from
the apparatus.

11)Only use attachments/
accessories specified by the
manufacturer.

12)Use only with the cart, stand,
tripod, bracket, or table
specified by the manufacturer,
or sold with the apparatus.
When a cart is used, use caution
when moving the cart/

2

apparatus combination t o avoid
injury from tip-over.

13)Unplug this apparatus during
lightning storms or when
unused for long periods of
time.

14)Refer all servicing to qualified
service personnel. Servicing is
required when the apparatus
has been damaged in any way,
such as power-supply cord or
plug is damaged, liquid has
been spilled or objects have
fallen into the apparatus, the
apparatus has been exposed to
rain or moisture, does not
operate normally, or has been
dropped.

Note about the discs

Do not use the following discs:
– A disc recorded in a color system

other than NTSC, such as PAL or
SECAM (this player conforms to
the NTSC color system).

– A disc that has a non-standard

shape (e.g., card, heart).

– A disc with a label or sticker on

it.

Region code

Your player has a region code
printed on the back of the unit and
only will play commercial DVDs
(playback only) labeled with
identical region codes. This system
is used to protect copyrights.

Commercial DVDs labeled
will also play on this player.

Depending on the commercial
DVD, there may be no region code
indication, even though playing the
commercial DVD is prohibited by
area restrictions.

DVP–XXXX

00V 00Hz

NO.

X

00W

0-000-000-00

ALL

Region code

• MPEG Layer-3 audio coding
technology and patents licensed
from Fraunhofer IIS and
Thomson.

• Windows Media is either a
registered trademark or
trademark of Microsoft
Corporation in the United States
and/or other countries.
This product contains
technology subject to certain
intellectual property rights of
Microsoft.
Use or distribution of this
technology outside of this
product is prohibited without the
appropriate license(s) from
Microsoft.

• This product meets ENERGY

®

guidelines for energy

STAR
efficiency.
ENERGY STAR and the
ENERGY STAR mark are
registered U.S. marks.
ENERGY STAR is a registered
mark owned by the U.S.
government.

About this manual

“DVD” may be used as a general
term for commercial DVDs,
DVD+RWs/DVD+Rs/DVD+R
DLs (+VR mode) and DVD-RWs/
DVD-Rs/DVD-R DLs (VR mode,
video mode).

Copyrights and trademarks

• Manufactured under license
from Dolby Laboratories. Dolby
and the double-D symbol are
trademarks of Dolby
Laboratories.

• “DVD Logo” is a trademark of
DVD Format/Logo Licensing
Corporation.

3

Playback

Control Menu display

Use the Control Menu to select a function and
to view related information.

Press DISPLAY.

To change the Control Menu display, press
DISPLAY again.

)

1 2 ( 2 7

)

1 8 ( 3 4
T

1 : 3 2 : 5 5

OFF
OFF
SET
ON

PROGRAM

ENTER DISPLAY

A Control Menu items
B Currently playing title/Total number of

titles

C Currently playing chapter/Total number

of chapters

D Playing time
E Selected media type
F Playback status
G Selected item icon/menu options
H Operation message
I Selected Control Menu item

Quit:

PLAY
DVD VIDEO

Menu list

Item Item Name, Function

TITLE/SCENE/TRACK

CHAPTER/INDEX

TRACK

Selects the title, scene, track, chapter, or index
to be played.

TIME/TEXT

Checks the elapsed time and the remaining
playback time.
Input the time code for picture and music search
(DVD only).

TOP MENU/MENU

(DVD VIDEO only)

TOP MENU: Displays the top menu.
MENU: Displays the menu.

ORIGINAL/PLAY LIST

Selects the type of title (DVD-VR mode) to be
played: ORIGINAL, or edited PLAY LIST.

PROGRAM*

Selects the title, chapter, or track to play in the
order you want.

1 Select “SET t,” then press ENTER and

select the title (T), chapter (C), or track (T)
you want to program, and press ENTER.

2 Repeat selecting the title, chapter, or track.
3 Press N.

SHUFFLE*

Plays the title, chapter, or track in random order.

REPEAT*

Plays all titles/tracks/albums or a single title/
chapter/track/album/file repeatedly.

A-B REPEAT*

Specifies the parts you want to play repeatedly.
1 During playback, select “SET t,” then

press ENTER.
The “A-B REPEAT” setting bar appears.

2 When you find the starting point (point A),

press ENTER.

3 When you reach the ending point (point B),

press ENTER again.

1, *2

1, *2

1, *2

1, *2

4