Sony DVP-S533D Service Manual
DVP-S533D
RMT-D108A
SERVICE MANUAL
SPECIFICATIONS
CD/DVD player
Laser Semiconductor laser
Signal format system NTSC
Audio characteristics
Frequency response DVD (PCM 96 kHz): 2 Hz to 44 kHz
(±1 dB)*
DVD (PCM 48 kHz): 2 Hz to 22 kHz
(±0.5 dB)
CD: 2 Hz to 20 kHz (±0.5 dB)
Signal-to-noise ratio More than 115 dB (LINE OUT (AUDIO 1,
2) connectors only)
Harmonic distortion Less than 0.0025%
Dynamic range More than 100 dB (DVD)
More than 97 dB (CD)
Wow and flutter Less than detected value
(±0.001% W PEAK)
Outputs and inputs
Jack Output Load impedance
type level
LINE OUT Phono 2 Vrms Over 10 kilohms
(AUDIO 1, 2) jacks (at 50 kilohms)
DIGITAL OUT Optical –18 dBm Wave length: 660 nm
(OPTICAL) output
connector
DIGITAL OUT Phono 0.5 Vp-p 75 ohms terminated
(COAXIAL) jack
LINE OUT Phono 1.0 Vp-p 75 ohms,
(VIDEO 1, 2) jacks sync negative
S VIDEO OUT 4-pin Y: 1.0 Vp-p 75 ohms,
(1, 2) mini DIN sync negative
C: 0.286 Vp-p 75 ohms terminated
COMPONENT phono Y: 1.0 Vp-p 75 ohms,
VIDEO OUT jacks sync negative
(Y, PB/B-Y, PB/B-Y,
PR/R-Y) PR/R-Y:
0.7 Vp-p 75 ohms
PHONES Phone 12 mW 32 ohms
jack
5.1CH Phono 2 Vrms Over 10 kilohms
OUTPUT jacks (at 50 kilohms)
PX Model
General
Power requirements 110 to 240 V AC, 50/60 Hz
Power consumption 16 W
Dimensions (approx.) 430 × 95 × 305 mm
(17 × 33/4 × 12 in.) (w/h/d)
incl. projecting parts
Mass (approx.) 3.4 kg (7 lb 8 oz)
Operating temperature 41°F to 95°F (5°C to 35°C)
Operating humidity 5% to 90%
Supplied accessories
• Audio/Video/S-link connecting cord (1)
• S video cable (1)
• Plug adaptor (1)
• Remote commander (remote) RMT-D108A (1)
• Size AA (R6) batteries (2)
* The signals from LINE OUT (AUDIO 1, 2) connectors and 5.1 ch L, R
connectors are measured. When you play the PCM sound tracks with
96 kHz sampling frequency, the output signals from the DIGITAL OUT
(OPTICAL, COAXIAL) are converted to 48 kHz (sampling frequency).
Design and specifications are subject to change without notice.
CD/DVD PLAYER
MICROFILM
DVP-S533D
TK-51 (RF/SERVO) SCHEMATIC DIAGRAM • See page 4-7 for printed wiring board and page 4-10 for waveforms.
– Ref. No.: TK-51 board; 2,000 series –
RF/SERVO
TK-51
Note:The components identified by mark ! or dotted line
with mark ! are critical for safety.
Replace only with part number specified.
4-11 4-12
MS-46 (LOADING) PRINTED WIRING BOARD AND SCHEMATIC DIAGRAM
– Ref. No.: MS-46 board; 3,000 series –
There are few cases that the part isn't mounted in this model is printed on this diagram.
MS-46 BOARD
S001
(TRAY SENSOR)
S001
CN001
DVP-S533D
LOADING
MOTOR
(CHUCK SENSOR)
11
05
Power Block (HS-030SF)
(SWITCHING REGULATOR)
FR-150
(IR/POWER SWITCH)
TK-51
(RF/SERVO)
AU-212
(AUDIO)
1-675-146-
(11)
HP-111
(HEADPHONE)
SW-317
(SURROUND SWITCH)
MS-46
(LOADING)
MB-85
FL-101
(FUNCTION SWITCH)
(SIGNAL PROCESS/SERVO)
4-13 4-14
LOADING
MS-46
DVP-S533D
MB-85 (AV DECODER) SCHEMATIC DIAGRAM •See page 4-15 for printed wiring board.
– Ref. No.: MB-85 board; 1,000 series –
AV DECODER
MB-85 (1/10)
4-19 4-20
MB-85 (SDRAM) SCHEMATIC DIAGRAM • See page 4-15 for printed wiring board.
– Ref. No.: MB-85 board; 1,000 series –
DVP-S533D
• Wavef orms
1 IC401 %¢
720 mVp-p (H)
2 IC401 %¶
728 mVp-p (H)
3 IC401 %•
5 IC401 ^™
816 mVp-p (H)
6 IC401 ^∞
1.2 Vp-p (H)
4 IC401 ^¡
1.0 Vp-p (H)
1.1 Vp-p (H)
SDRAM
4-224-21
MB-85 (2/10)
DVP-S533D
1 IC701 ^ª (DVD play)
500 mV/DIV 50 ms/DIV
1.4 Vp-p
2 IC701 ^ª (CD play)
500 mV/DIV 200 mV/DIV
1.7 Vp-p
3 IC701 ^• (DVD play)
100 mV/DIV 5 ms/DIV
180 mVp-p
4IC701^• (CD play)
500 mV/DIV 50 ms/DIV
860 mVp-p
MB-85 (SERVO DSP) SCHEMATIC DIAGRAM • See page 4-15 for printed wiring board.
– Ref. No.: MB-85 board; 1,000 series –
• Wavef orms
SERVO DSP
MB-85 (3/10)
4-23 4-24
Loading...