SONY DVP-S360, DVP-S560D, DVP-S570D, DVP-C660, DVP-C670D Service Bulletin

Page 1
[Sony Service]
Technical Services
Electronic Service Information
Field Problem Reports
-----------------------------------------------------------------------­ FPR Number: Submitted by: Tremble, C. Engineer: TC Model(s): DVPS560D
Subject: No part number listed for IC101 Symptom: Last Update: 2001-05-08 Status: Closed
Customer Description: Missing Part Number Solution: IC101 Part# 9-885-005-99 Technical Description: No part number is listed for IC1010 in s/m for board SRV940JUC. Schematic is also incorrect in calling IC101 an - ON3131. A ON3131 is an opto isolator. IC101 is drawn as a power control FET type integrated circuit.
Part's Information: P/N Description Reference Board Symptom
----------------------------------------------------------------------------------­ 9-885-005-99 SRV940JUC IC101
Page 2
Sony Service Company National Technical Services A Division of Sony Electronics Inc. Park Ridge, New Jersey 07656
CONFIDENTIAL
Service Bulletin Multi-Disc Players
CSV-5
Model: DVP-S360, DVP-S560D, DVP-S570D, DVP-C660,
No.
DVP-C670D
Subject: PLAYER MAY NOT PLAY CD/DVD OR VCD Date:
Symptom:
(111A)
Solution:
The DVD player may not play disc. The display may indicate "No Disc "or C:13:00"
Please remove fuse F402 and replace with 0-ohm resistor on MB board (side B). Next, exchange resistors R416 and R418. The original values are 150K, change them both to 82K ohms
REF DESCRIPTION PART NUMBER
F402 CONDUCTOR, CHIP(2012)
METL RES 0H 1/10W
R416/
R418
There are 2 types of MB-bds depending on model. DVPS360, Dvps560D, DVPS570D (mb-86) DVPC660, DVPC670D is (mb-87)
RESISTOR,CHIP 82K 1/16W 1-216-844-11
1-216-295-11
68
September 8, 2000
Reference: HVDK00e007
PRINTED IN USA
Page 3
Multi-Disc Products Ser vic e Bul let in No. 68
.
3. Measure the resistor between Pin # 21 & Pin # 22 of the Flexible Cable, which is connected with the OPT. (See the fi gur e below.) If the resistor between Pin # 21 & Pin # 22 is below 6 ohms , replace the OPT to the new one.
4. Please do servo adjustment,af t er replacing components and/or optical.
Loading...