Sony 454RF - CDX CD Changer, CDX-454XRF, CDX-454RF Operating Instructions Manual

SONY@
3-237-554-13 (2)
Compact Disc Changer
System Sistema de Cambiador de.
discos compactos
Operating Instructions
POR FAVOR LEA DETALLADAMENTE ESTE MANUAL DE INSTRUCCIONES ANTES DE CONECTAR Y OPERAR
RECUERDE QUE UN MAL US0 DE SU APARATO
Owner’s Record
The model and serial numbers are located at the rear of the CD changer. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product.
Model No. CDX-454RF Serial No.
For installation and connections, see the supplied installation/connections
manual. En ce qui concerne l’installation et les connexions, consulter le manuel
d’installation/connexions fourni. Con respect0 a la instalaci6n y a las conexiones, cons&e el manual de
instalaci6n/conexiones suministrado.
CDX-454XRF CDX-454RF
@TiFrg
DIGITALAUDIO
0 2001 Sony Corporation
For the customers in the USA (CDX-454RF only)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/ TV technician for help.
You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate
this equipment.
CAUTION
The use of optical instruments with this product will increase eye hazard.
Welcome!
Thank you for purchasing the Sony CD changer system. This unit lets you enjoy CD sound with the changer.
The CDX-454XRF/454RF is a compact disc changer system comprised of the wired remote commander, the relay box, and the CD changer. The CD changer modulates the audio signal into the RF (Radio Frequency) signal so that it can be received by the existing FM tuner of your car audio. Therefore you will be able to enjoy CD play with your car audio even if it has no input terminals for a compact disc player.
l
Compact and space saving CD changer for vertical, horizontal, suspended, or inclined installation in your car.
l
Supplied wired remote enables you to control the CD changer installed in the trunk room of your car.
l
Repeat play function for playing a track or a disc repeatedly.
l
Shuffle play function for playing tracks of one disc or of all discs in random order.
l
D-BASS function for dynamic bass boot.
2
Table of contents
Getting Started
Resetting
the
unit .................................................
4
Preparing
the CD changer
..................................
4
Changing the transmitting frequency
...............
5
CD Changer
Listening to a
CD
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ,.. . . . . . . . . . . . . . . . .
6
Playing tracks in random order
- Shuffle
Play
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7
Playing tracks repeatedly
- Repeat Play
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7
Boosting the bass sound
-
D-bass . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7
Changing the
output level
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8
Additional Information
Precautions .
...........................................................
9
Notes
on handling discs
......................................
9
Maintenance
........................................................
10
Location of controls
...........................................
11
Specifications
......................................................
12
Troubleshooting
guide
...................................... 13
3
Resetting the unit
Before operating the unit for the first time or after replacing the car battery, you must reset the unit. Press the reset button with a pointed object, such as a ball-point pen, etc.
Reset button
I
Preparing the CD changer
1
With the arrow side facing up
I
JI
Labelled surface up
10 discs, one in each tray
2
Push to unlock the door
Slide open
+
Note
To prevent injury, do not insert your hand in the
CD changer.
Disc magazine
& (EJECT)
4
disc magazine or the disc magazine XA-250. The disc magazine XA-IOBI XA-350 cannot be used with this unit. If you use any other disc magazine, it may cause a
4
Note
You cannot play 8cm (3in.) CDs.
If the disc magazine does not lock properly Take out the disc magazine, press A, and re­insert it.
Use the unit with the door closed completely Otherwise, foreign matter may enter the unit and
contaminate
the lenses inside the CD
changer.
Notes on the disc magazine
l
Do not leave the disc magazine in locations with high temperature and high humidity, such as on a car dashboard or in the rear window where the disc magazine will be subject to direct sunlight.
l
Do not place more than one disc at a time onto a tray, otherwise the CD changer and the discs may be damaged.
l
Do not drop the disc magazine or subject it to a violent shock.
When the tray comes out
Normally, the trays will not come out of the disc magazine. However, if they are pulled out of the disc magazine, it is easy to re-insert them.
With the cut-away portion of the tray facing you, insert the right corner of the tray in the slot, then push in the left corner until it clicks.
Changing the transmitting frequency
Because this unit processes CD playback sound through an FM tuner, there may be interference noise during CD playback. In such a case, change the frequency of the modulated RF signal transmitted from the unit. The initial setting is 88.3 MHz.
1
2
Press
( SHUF~REP)
for two seconds until
frequency appears.
Press (DISC+) or (Disc-) repeatedly to select the frequency. Each time you press (DISC+) or (DISC-), the frequency changes as follows:
(DISC-) :
88.3
MHz + 89.9
MHz -+ 89.7 MHz
-+
89.5
MHz + 89.3
MHz --+ 89.1 MHz
--+
88.9
MHz -+ 88.7
MHz ---, 88.5 MHz
--.
88.3
MHz
(DISC+) :
88.3
MHz -+ 88.5
MHz --+ 88.7 MHz
+
88.9
MHz --+ 89.1
MHz --+ 89.3 MHz
--+
89.5
MHz -+ 89.7
MHz -+ 89.9 MHz
-+
88.3
MHz
3
Press
(SHUF~REP)
for two seconds.
Notes
l
When you change the transmitting frequency on the unit, be sure to tune your FM tuner to the
newly selected one.
l
Press ,II on the wired remote before changing the frequency if the power to the unit is turned off.
Note Do not insert the tray upside down or in the wrong direction.
5
Listening to a CD
1 2
3
4
Turn on the FM tuner of your car audio.
Tune in the selected transmitting frequency* with the FM tuner of your car audio.
* The frequency of the unit is set to 88.3 MHz
at the factory.
You can change the frequency. (See “Changing the transmitting frequency” on
page 5.)
Press )II.
CD playback starts.
Adjust the volume with the volume control on your car audio.
All the tracks play from the beginning.
Stopping CD play
Press (OFF).
Notes
Note Be sure to stop CD playback, otherwise there may be some interference with radio reception.
l
When CD playback stops, you may hear some noise from the speakers. To prevent this from happening, turn the volume down before stopping CD playback.
l
lfyou turn off the ignition switch of your car without stopping CD playback, it will automatically resume CD playback from where it was stopped when you turn on the ignition switch again.
Locating a specific track
- Automatic Music Sensor (AMS)
During CD playback, push down either side of (AMS) once for each track you wish to skip.
Locating a specific point in a track
- Manual Search
During CD playback, push down and
hold either side of (AMS). Release the control when you have found the desired point.
To
search
backward
To
search
forward
Locating a specific disc
- Disc Select
During CD playback, press (DISC+) or
(DISC-] once for each disc you wish to skip.
To
locate succeeding discs
To
locate previous discs
Listening to the radio or a tape
Be sure to stop CD playback before you start listening to the radio or a tape.
To
locate previous tracks
To
locate succeeding tracks
6
Loading...
+ 14 hidden pages