Sony 4-187-903-11(1), KDL-40LX903 User Manual
4-187-903-11(1)
LCD
Digital Colour TV
Operating Instructions
Setting Up
Watching TV
Additional Information
KDL-60LX903 / 40LX903
NOTICE FOR
CUSTOMERS IN
THE UNITED
KINGDOM
A moulded plug complying with BS1363 is
fitted to this equipment for your safety and
convenience.
Should the fuse in the plug s upplied need to
be replaced with the same rating of fuse
approved by ASTA or BSI to BS 1362 (i.e.,
marked with or ) must be used.
When an alternative type of plug is used it
should be fitted with the same rating of
fuse, otherwise the circuit should be
protected by a 10 AMP FUSE at the
distribution board.
If the plug supplied with this equipment has
a detachable fuse cover, be sure to attach
the fuse cover after you change the fuse.
Never use the plug without the fuse cover.
If you should lose the fuse cover, please
contact your nearest Sony service station.
FUSE
FUSE
How to replace the fuse
Open the fuse compartment with a blade
screwdriver, and replace the fuse.
Please refer to the illustration that actually
equipped with the product.
Introduction
Thank you for choosing this Sony product.
Before operating the TV, please read this
manual thoroughly and retain it for future
reference.
The manufacturer of this product is
Sony Corporation, 1-7-1 Konan
Minato-ku Tokyo, 108-0075 Japan.
The Authorized Representative for
EMC and product safety is Sony
Deutschland GmbH, Hedelfinger
Strasse 61, 70327 Stuttgart,
Germany. For any service or
guarantee matters please refer to the
addresses given in separate service
or guarantee documents.
GB
2
Notes on Digital TV
function
• Any functions related to Digital TV
( ) will only work in countries or
areas where DVB-T (MPEG-2 and
H.264/MPEG-4 AVC) digital terrestrial
signals are broadcast or where you have
access to a compatible DVB-C (MPEG2 and H.264/MPEG-4 AVC) cable
service. Please confirm with your local
dealer if you can receive a DVB-T signal
where you live or ask your cable
provider if their DVB-C cable service is
suitable for integrated operation with
this TV.
• Your cable provider may charge a fee for
their services, or require you to agree to
its terms and conditions of business.
• This TV set complies with DVB-T and
DVB-C specifications, but compatibility
with future DVB-T digital terrestrial and
DVB-C digital cable broadcasts are not
guaranteed.
• Some Digital TV functions may not be
available in some countries/areas and
DVB-C cable may not operate correctly
with some providers.
For a list of compatible cable providers,
refer to the support web site:
http://support.sony-europe.com/TV/
DVBC/
~
• Instructions about “Installing Wall
Mount Bracket” are included within this
TV’s instructions manual.
• The illustrations used in this manu al may
differ depending on your TV model.
Trademark information
is a registered trademark of the DVB
Project.
HDMI, the HDMI Logo, and HighDefinition Multimedia Interface are
trademarks or registered trademarks of
HDMI Licensing LLC in the United States
and other countries.
DLNA®, the DLNA Logo and DLNA
CERTIFIED® are trademarks, service
marks, or certification marks of the Digital
Living Network Alliance.
DivX® is a video file compression
technology, developed by DivX, Inc.
DivX, DivX Certified, and associated
logos are trademarks of DivX, Inc. and are
used under license.
ABOUT DIVX VIDEO: DivX® is a
digital video format created by DivX,Inc.
This is an official DivX Certified device
that plays DivX video. Visit
www.divx.com for more information and
software tools to convert your files into
DivX video.
ABOUT DIVX VIDEO-ON-DEMAND:
This DivX Certified® device must be
registered in order to play DivX Video-onDemand (VOD) content. To generate the
registration code, locate the DivX VOD
section in the device setup menu. Go to
vod.divx.com with this code to complete
the registration process and learn more
about DivX VOD.
Manufactured under license from Dolby
Laboratories. Dolby and the double-D
symbol are trademarks of Dolby
Laboratories.
“BRAVIA” and are
trademarks of Sony Corporation.
” and “XrossMediaBar” are
“XMB
™
trademarks of Sony Corporation and Sony
Computer Entertainment Inc.
“FACE DETECTION” logo is trademark
of Sony Corporation.
Notice for Wireless
Signal
1. Hereby, Sony, declares that this unit is
in compliance with the essential
requirements and other relevant provisions
of Directive 1999/5/EC.
To obtain the declaration of conformity
(DoC) for R&TTE Directive, please access
the following URL address.
http://www.compliance.sony.de/
2. TV wireless system may be operated in
following EU countries:
Austria, Belgium, Bulgaria, Cyprus, Czech
Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary,
Iceland, Ireland, Italy, Latvia,
Liechtenstein, Lithuania, Luxembourg,
Malta, The Netherlands, Norway, Poland,
Portugal, Slovak Republic, Romania,
Slovenia, Spain, Sweden, Switzerland,
Turkey, and The United Kingdom.
This equipment can be operated in other
non-European countries.
Location of the
identification label
Labels for Model No. and Power Supply
rating (in accordance with applicable
safety regulation) are located on the rear of
the TV. They can be found by removing
the bottom cover.
Table of Contents
Checking the accessories ..............................................................................................................3
Inserting batteries into the remote .................................................................................................3
Setting Up
Attaching the Table-Top Stand (except KDL-60LX903).................................................................4
Connecting an antenna (aerial)/Set Top Box/recorder (e.g. DVD recorder)..................................5
Preventing the TV from toppling over ............................................................................................6
Bundling the cables........................................................................................................................6
Performing the initial set-up ...........................................................................................................7
Detaching the Table-Top Stand from the TV .................................................................................7
Watching TV
To watch programmes ...................................................................................................................8
To utilise the TV’s features ............................................................................................................8
To use i-Manual .............................................................................................................................9
To use 3D Glasses ......................................................................................................................10
Additional Information
Troubleshooting...........................................................................................................................12
Specifications...............................................................................................................................13
Installing the Accessories (Wall-Mount Bracket)..........................................................................15
Safety Information........................................................................................................................20
Precautions..................................................................................................................................21
• Operating instructions are built into your BRAVIA TV. Refer to “To use i-Manual” for operation (page 9).
• Before operating the TV, please read “Safety Information” (page 20). Retain this manual for future reference.
2
*
For KDL-60LX903, the stand rear cover is
Checking the accessories
AC power cord (mains lead) (1)
factory-attached to the Table-Top Stand.
3
For KDL-60LX903, the bottom cover is factory-
*
attached to the TV.
Cable holder (1) (except KDL-60LX903)
Remote (1)
Size AAA batteries (R3 type) (2)
Table-Top Stand (1)
*1 (except KDL-60LX903)
Inserting batteries into the remote
Fixing screws for Table-Top Stand
(M5 × 16) (4) (except KDL-60LX903)
Assembling screws for Table-Top Stand
(M5 × 16) (4) (KDL-40LX903 only)
Black spacers (4) (KDL-40LX903 only)
Silver spacers (4) (KDL-60LX903 only)
Screws (M6 × 20) (4) (KDL-60LX903 only)
Stand rear cover (1)*
Bottom cover (1)*
2
3
3D Glasses (battery included) (2)
Pouch for 3D Glasses (2)
*1For KDL-40LX903, assemble the Table-Top
Stand with the supplied assembling screws.
Refer to the supplied Table-Top Stand leaflet to
assemble the stand.
1 Remove the protection sheet.
2 Push and slide the cover upward.
GB
3
Setting Up
Attaching the Table-Top
Stand (except KDL60LX903)
1 Refer to the supplied Table-Top Stand
leaflet for proper attachment for some
TV models.
2 Place the TV set on the Table-Top
Stand.
3 Fix the TV to the Table-Top Stand
according to the arrow marks that
guide the screw holes using the
supplied screws.
Adjusting the viewing angle of
the TV (except KDL-60LX903)
This TV can be adjusted within the angles
shown below.
6º0º
1
4
~
• If using an electric screwdriver, set the tightening
torque at approximately 1.5 N·m {15 kgf·cm}.
4 After all the screws have been
tightened, attach the supplied stand rear
cover to the Table-Top Stand.
Remove screw as
shown.
2
~
• To return to 0°, reverse the above procedure.
Install screw into
the top screw hole
of the Table-Top
Stand.
3
Slide in.Lift up and tilt.
GB
4
• Ensure that there are no objects in front of the TV.
IR Sensor
Connecting an antenna (aerial)/Set Top Box/ recorder (e.g. DVD recorder)
3D Sync Transmitter
Intelligent Presence Sensor
• Do not expose the Intelligent Presence Sensor to
direct sunlight or other strong light, as
malfunction may occur.
Connecting a Set Top Box/recorder
(e.g. DVD recorder) with SCART
Setting Up
Set Top Box/recorder (e.g. DVD recorder)
~
• Right Angle Type Universal SCART Lead is
recommended for this connection.
Connecting a Set Top Box/recorder
(e.g. DVD recorder) with HDMI
Set Top Box/recorder (e.g. DVD recorder)
(Continued)
GB
5
~
• For KDL-40LX903, after connecting cables,
install the bottom cover and stand rear cover.
Detaching the terminal cover
~
• After connecting cables, re-attach the terminal
cover to the TV.
Preventing the TV from toppling over
3 Tie the wood screw and the machine
screw with a strong cord (not supplied).
Bundling the cables
~
• A cable holder is available for KDL-40LX903. To
bundle the cables, follow steps 3 to 5.
1 Install a wood screw (4 mm in
diameter, not supplied) in the TV stand.
2 Install a machine screw (M4 × 16, not
supplied) into the screw hole of the TV.
~
• Do not bundle the AC power cord (mains lead)
together with other cables.
GB
6
Performing the initial set-up
Programme Sorting: Changes the order of
analogue channels stored in the TV.
1 Press F/f to select the channel you want
to move to a new position, then press .
2 Press F/f to select the new position for
the channel, then press .
~
• You can also tune channels manually.
1 Connect the TV to your AC power
outlet (mains socket).
2 Check the ENERGY SAVING
SWITCH setting is on (
z).
3 Press 1 on the TV.
When you switch on the TV for the first
time, the Language menu appears on the
screen.
4
Follow the instructions on the screen.
Digital Auto Tuning: When you select
“Cable”, we recommend that you select
“Quick Scan” for quick tuning. Set
“Frequency” and “Network ID” according
to the information supplied from your cable
provider. If no channel is found using
“Quick Scan”, try “Full Scan” (though it
may take some time).
Setting Up
Detaching the Table-Top Stand from the TV
~
• Remove the stand rear cover and bottom cover
prior to detaching the Table-Top Stand.
• Remove the screws guided by the arrow marks
of the TV.
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
• Be sure the TV is on the vertical position before
switching on. TV set must not powered on with
LCD panel face down to avoid uneven picture
uniformity.
For a list of compatible cable providers,
refer to the support web site:
http://support.sony-europe.com/TV/
DVBC/
GB
7
Watching TV
To watch programmes
Turn on the TV.
1
2
GUIDE
OPTIONS
HOME
3
z
• The number 5, N, PROG + and AUDIO
buttons on the remote have a tactile dot.
Use the tactile dots as a reference when
operating the TV.
1 Switch ENERGY SAVING SWITCH
z).
on (
2 Press 1 on the TV to turn on the TV.
Select a mode.
2
Select a TV channel.
3
Using Digital Electronic Programme
Guide
Press GUIDE in digital mode to display the
programme guide.
To utilise the TV’s features
HOME button
Press to display various operation and setting
screens.
Settings
System Settings
TV
GB
8
OPTIONS button
Press to display convenient functions based on
the current input or content.
Picture
Sound
3D Menu
Add to Favourites
PAP
Motionflow
Presence Sensor
Scene Select
Sleep Timer
Headphone Volume
Speakers
Loading...