Sony 170S7 User Manual
Quick-Use Guide
Cable Box with RF In/Out Jacks
This connection will not supply Stereo sound to the LCD TV Monitor. The sound from the Cable
Box will be monaural (single-channel, not left and right).
1
Connect the Cable TV signal to the IN jack (or RF IN or CABLE IN) on the Cable
Box.
2
Connect an RF coaxial cable (not supplied) to the OUT jack (or TO TV or RF OUT)
of the Cable Box.
3
Connect the other end of the coaxial cable to the TV jack on the LCD TV Monitor.
Screw it down finger tight.
4
Set the Channel 3/4 (or Output channel) switch of the Cable Box to 3 or 4. Set the TV to
the same channel. When watching TV programming, change channels at the Cable Box,
not the LCD TV Monitor.
2
There are several ways to connect your new LCD TV Monitor to your other
equipment. This Quick-Use Guide shows the easiest most common connection.
Cable TV signal from
the Cable Company
75Ω
Coaxial
Cable
75Ω jack on rear
of Television
NOTE: To see how to make other connections, please refer to the Owner’s
Manual.
1
CABLE
IN
TV
S-VIDEO
VIDEO
DC IN
AUDIO OUT
1 2
ANALOG
AUDIO
TO TV
TV
OUTPUT
CH
3 4
3
Quick-Use Guide
Auto Program
1
Press the MENU button on the
remote control to show the onscreen
menu.
2
Press the (CH UP) or (CH DN)
buttons to highlight the TV
INSTALL menu.
3
Press the (VOL-) or(VOL+) buttons to enter the TV INSTALL menu.
4
Press the (CH UP) or (CH DN)
buttons to highlight the AUTO PRO-
GRAM control.
5
Press the (VOL+) or(VOL-) button to start the Auto Program scan-
ning of channels.
6
Press the MENU button repeatedly
to clear the menu from the screen.
EL6568E001
LCD TV Monitor Swivel
1
Press down on the stand and gently
adjust the set to a suitable viewing
angle.
NOTE:The LCD TV Monitor can only be
tilted 20 degrees backward and 5
degrees forward.
You can adjust the LCD TV Monitor
to the left and right 60 degrees.
O
0
60
SWIVEL ANGLE-L
SWIVEL ANGLE-R
1
6
6
2
3
4
5
3
5
2
4
Loading...