SONIQ AWM3003 User Manual

AWM3003 AWM3003

(A)M5×8 ×6

(B)M5×15 ×4

(C)M5×30 ×4

(D)M6×8 ×4

(E)M6×15 ×4

(F)M6×30 ×4

(G)M8×15 ×4 (H)M8×30 ×4

(I)M8×20 ×10

(J)M8×40 ×12 (K)M8×65 ×4

(M)M8 Locknut ×4(L)

Ø6

Washer ×4

(N)

8 Washer ×40 (O)M8 Locknut ×10 (P)M8 Spring shim ×16

(Q)Plastic sleeve ×4

(R)Square shim ×4 (S)Inner hexagon spanner S=5 ×1

(T)Inner hexagon spanner S=6 ×1 (U)S=6 Universal wheel ×4

(V)U-Steel holder ×1 (W)Top plate ×1 (X)Left lower pole ×1

(Y)Right lower pole ×1

(Z)Connective plate ×1

(AA)Left bracket ×1

(AB)Right bracket ×1

(AC)Supporting pole ×1

(AD)Flat roof plate ×1

(AE)Upper vertical ×1

(AF)Gusset plate ×2

STEP-1 STEP-2

STEP-3 STEP-4

Mount the universal wheel to the thread hole of M12 in the left lower pole and then screw down the M12 nut.

Mount the universal wheel to the thread hole of M12 in the right lower pole and then screw down the M12 nut.

Join the left lower pole, right lower pole and U-steel holder with M8×40 bolt pre-through a M8 washer and a M8 Spring shim, and then screw down with a S=6 spanner.

Join the supporting pole with a M8×20 bolt pre-through a M8 washer and a M8 Spring shim, then screw down with a S=6 spanner.

Note: When mounting, align the pins and holes in the poles.

M12 nut

Before installing the mobile TV floor stand product, please make sure your unit installing holes are well-prepared

STEP-5

STEP-8

STEP-6

STEP-9

STEP-10

STEP-11

STEP-7

Install the two gusset plates onto the U-steel holder and the supporting pole with some bolts,washer and nuts as shown in the fig.

Mount the upper vertical pole assembled with the top plate with four M5×8 bolts as a height needed for the TV and screw down with a cross screwdriver.

Mount two M5×8 cross bolts to the upper vertical pole and screw down with a cross screwdriver. Shown as the fig.

Hang the two monitor brackets together with the panel TV on the connective plate, relax the hands until they are caught hold of.

Install the monitor brackets onto the back of the panel TV: screw two bolts into the holes in the back of the panel TV to install each monitor bracket.

B/C/E/F/G/H

Join the connective plate and supporting pole with M6×65 inner hex bolt pre-through a flat washer and then screw down the bolt with S=5 spanner. Shown as the fig.

Join the flat roof plate and supporting pole with a M6×15 bolt pre-through a M6 washer and then screw down with a cross screwdriver.

Mobile Floor Stand Installation for Panel TV

This product is designed to mount flat panel televisions weighing up to 132lbs/60kgs with maximum flat panel mount installing hole dimensions 80 cm(width) × 60 cm(height). It allows you to effortlessly tilt your new televusion up or down without using tools.

Mobile Floor Stand Installation for Panel TV