Sonicwall 069 User Manual

SonicPoint_N_GSG.book Page 47 Friday, February 6, 2009 12:10 PM

FCC Part 15 Class B Notice for the
SonicWALL SonicPoint Wireless
Appliance

NOTE: This equipment was tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy. And, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If the
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try and correct the interference using one or
more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from the
receiver connection.

• Consult SonicWALL for assistance.

Complies with EN55022 Class B and CISPR22 Class B.
*Refer to the label on the bottom of the unit for device information
including Class A or Class B FCC information.

FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.

This device is restricted to indoor use only. Regardless of channel
setting, transmission on 5600 MHz to 5650 MHz is blocked.
FCC and IC RF Radiation Exposure Statement

This equipment complies with FCC and IC RF radiation exposure limits
set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 20 centimeters (7.9
inches) between the radiator (antenna) and your body. This transmitter
must not be co-located or operating in conjunction with any other
antenna or transmitter.

For more information regarding the above statement, please contact
SonicWALL, Inc. at:
1143 Borregas Avenue
Sunnyvale, CA, 94089-1306
1-408-745-9600

North American Authorized Channels

SonicWALL declares that the APL21-069 (FCC ID: QWU-069)
(IC: 4408A-069) when sold in US or Canada is limited to CH1~CH11 by
specified firmware controlled in the USA.

Canadian Radio Frequency Emissions Statement

This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB­003 du Canada.

Industry Canada Statement

This device complies with RSS-210 of the Industry Canada Rules.
Operation is subject to the following two conditions:

FCC and IC

(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.

Caution:

The device for the band 5150-5250 MHz is only for indoor usage to
reduce potential for harmful interference to co-channel mobile satellite
systems.

This device has been designed to operate with an antenna having a
maximum gain of 4 dBm. Antenna having a higher gain is strictly
prohibited per regulations of Industry Canada. The required antenna
impedance is 50 ohms.

Page 47 FCC Part 15 Class B Notice for the SonicWALL SonicPoint Wireless Appliance