Sonance MAG6 LCR, SONOS AMP, SONANCE TV Box Instruction Manual

MAG CONCEALED TV

AUDIO SYSTEM

INSTRUCTION MANUAL

MAG6 LCR | SONOS AMP | SONANCE TV Box

Scan QR code

for setup video

INSTRUCTION MANUAL MAG CONCEALED TV AUDIO SYSTEM

IMPORTANT SAFETY INFORMATION

You should always follow these basic safety precautions when using your Sonance MAG Concealed TV Audio System, to reduce the risk of ﬁre, electric shock, and injury to persons:

1. Read and retain instructions: Read all the safety and operating

instructions before operating the ampliﬁer, and retain them for future reference.

2. Heed warnings: Adhere to all warnings and precautions listed on the ampliﬁer and in the operating instructions.

3. Follow instructions: Follow all operating instructions.

4. Water: Never use the ampliﬁer next to water.

5. Carts and stands: The ampliﬁer should be

used only with a cart or stand that is recommended by the manufacturer. An ampliﬁer and cart combination should be moved with care.

6. CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT USE THE POLARIZED PLUG WITH AN EXTENSION CORD, RECEPTACLE, OR OTHER OUTLETS UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

7. Ventilation: The Subwoofer should be situated so that its location or position does not interfere with its proper ventilation. For example, the subwoofer should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or be placed in a built-in situation, such as a book case or a cabinet, that may impede the ﬂow of air over the subwoofer.

• The ampliﬁer has been exposed to rain.

• The ampliﬁer does not appear to operate normally or exhibits a marked change in performance.

• The ampliﬁer has been dropped, or the enclosure damaged.

16. Servicing: The user should not attempt to service the ampliﬁer beyond that described in the operating instructions. All other servicing should be referred to qualiﬁed service personnel.

17. Lifting: Improper lifting of the 28 lbs. MS10 SUB can cause personal injury.

18. Power requirement: Do not connect the Subwoofer to the accessory outlet of any other component. A minimum 15 amp (20 amp preferred) grounded wall outlet is required.

WARNING: THE POWER (MAINS) PLUG SERVES AS THE AMPLIFIER’S DISCONNECT DEVICE. THE DISCONNECT DEVICE SHALL REMAIN READILY OPERABLE DURING OPERATION. TO ENSURE THAT THE DISCONNECT DEVICE (POWER PLUG) IS EASILY ACCESSIBLE, THE USER SHALL NOT PLACE THE AMPLIFIER IN A CONFINED AREA DURING OPERATION.

19. Storms: To prevent damage to components, unplug all electronic equipment during thunderstorms.

8. Heat: Situate the ampliﬁer away from heat sources such as radiators, stoves, or other appliances (including external ampliﬁers) that produce heat.

9. Grounding or polarization: Grounding or polarization are precautions that should be taken so that these attributes are not defeated.

10. Power-cord protection: Route power supply cords so that they will not be walked on or pinched by items placed on or against them.

11. Cleaning: To clean the ampliﬁer, use “canned air” or wipe the ampliﬁer with a soft cloth. Do not use solvents, as they may damage the ampliﬁer.

12. Non-use periods: Unplug the ampliﬁer’s power cord from the outlet when the ampliﬁer will be left unused for a long period of time.

13. Object entry: Care should be taken so that objects do not fall through the opening of the enclosure.

14. Moisture: Do not expose the ampliﬁer to dripping or splashing. Do not place objects ﬁlled with liquids, such as vases, on the ampliﬁer.

15. Damage requiring service: Have the ampliﬁer serviced by a qualiﬁed service personnel when:

• The power supply cord or the plug has been damaged.

NOTE: SONANCE RECOMMENDS USING BEST BUY’S PROFESSIONAL INSTALLATION SERVICE FOR ANYONE NOT FAMILIAR WITH THE PROCESS OF RETROFITTING LOW VOLTAGE WIRING

• Objects have fallen, or liquid has been spilled into the ampliﬁer.

INTRODUCTION

Centered Oset

Sonancet TV Box installs behind your TV

Outline indicates your TV

Sonance TV Box installs behind your TV

Outline indicates your TV

Thank you for purchasing MAG Concealed TV Audio System. When properly installed your new speakers will give you

years of entertainment pleasure.

BOX CONTENTS

MAG Concealed TV Audio System box contains:

(2) MAG6 LCR Speakers (1) SONOS AMP (1) SONANCE TV Box and Mounting Bracket (2) SONANCE TV Box Spacers (1) Power Bridge ONE-CK Power Wall Box (1) Power Strip with USB (1) Mounting Screws and Velcro Kit (2) Wire Grommets

TOOLS NEEDED:

1. Electric Screw Driver

2. Tape Measure

3. Level

4. Stud Finder

5. Drywall Saw

6. Wire Strippers

7. Pencil

TOOLS RECOMMENDED:

1. Steel Fish Tape or Fish Rods

2. Hole Saw or Spade Bits

NEEDED ITEMS:

1. Speaker Wire

MAG PREMIUM SPEAKER PLACEMENT

MAG6 LCR - Left & Right Speakers

1. Place the left and right speakers 6 – 10 feet (1.8m – 3m) apart from each other. SONANCE recommends installing the center of the speakers as close to the center the TV, ideally at ear level when seated. See Figure 1

2. The main listening position should be 4 – 15 feet (1.2m – 4.5m)

away from the speakers and TV.

3. Once you have identiﬁed the desired mounting location and have checked for obstructions, use the included cutout template and a level to mark the cut lines for the speaker mounting hole. Then, cut the mounting hole using a drywall

saw, see the template provided with the speakers for cut out dimensions.

Left and Right

LCR Speakers

6’-10’

(1.8m - 3m)

Apart

Overhead View

BEFORE INSTALLATION

Determine the location for the speakers and Wall Box (see before you begin below).

Perform an obstruction survey using a stud ﬁnder to be certain that there are no studs, conduit, pipes, heating, ducts, pocket doors or air returns in the wall cavity that will interfere with the speaker or SONANCE TV Box.

If you are unsure about obstructions, drill a small hole in the center of the outline and insert a coat hanger wire into the hole to feel around for possible obstructions.

NOTE: CONSULT LOCAL BUILDING CODES BEFORE RUNNING AC WIRES AND SPEAKER WIRES THROUGH WALLS.

BEFORE YOU BEGIN

Plan your layout of your TV, TV bracket, SONANCE TV Box and Speakers before cutting any holes.

1. IMPORTANT: Determine the ﬁnal location where you want your TV when the install is complete, this will determine were you place the TV bracket, SONANCE TV Box and the Speakers.

2. Once you have determined the ﬁnal install location of where your TV will be installed measure and mark o with tape the top and the bottom of where the TV will be installed.

3. Measure from the top and bottom of the marked location to determine the center location of the TV when mounted and mark the center location with tape on each side of the TV.

4. Install the TV bracket arms onto the TV, measure and determine where to mount the TV braket so the TV hangs in the ﬁnal location you have previously measured in step

2. Mark the location of the TV bracket.

5. Once you have determined where your TV bracket will be installed, determine if the SONANCE TV Box will be installed above or below the TV bracket to best conceal the SONANCE TV Box but still allows access to electronics when the TV is installed.

6. Mark the location of the SONANCE TV Box.

7. For more assistance; watch the setup videos by scanning the QR code on the front cover.

4’-15 From Speakers

Figure 1

SONANCE TV BOX PLACEMENT

SONANCE TV Box (Figure 2)

• Determine The center location of your television ﬁrst.

• The SONANCE TV Box is designed to be installed between two studs. If the center of your TV Covers a stud, position the SONANCE TV Box to the left or right of the center stud.

Figure 2

+ 5 hidden pages