Somfy Systems TELIS1 User Manual

INSTALLATION guide-Telis 1

1. Characteristics:

Power: 3V lithium battery, CR 2430

•

Operating Temperature: + 5°C to +40°C

•

Range: Minimum 90’

•

Battery Life: 3 years assuming 4 operations per day

•

2. Programming:

While the RTS motor is in programming mode, press

•

the PROG button located on the back of t he
transmitter.

A series of three beeps will be heard from the RTS

•

motor indicating the RTS motor has been
successfully programmed.

Press the PROG button on the transmitter to exit the

•

programming mode.

3. Operation:

Press the UP, STOP, or DOWN button for desired

•

operation.

During transmission, the LED on the f ront of the

•

transmitter will illuminate. If it doesn’t replace the
battery.

in a commercial environment.

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

Connect the equipment into an outlet on a circuit different from that

Hand Held Transmitters

(1810632, 1810643, 1810639, 1810650)

FCC Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that
may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits
for a CLASS B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this

encouraged to try and correct the interference by one or more of the
following measures:

1.1 Reorient or relocate the receiving antenna.

1.2 Increase the separation between the equipment and receiver.

1.3
to which the receiver is connected.

1.4 Consult the dealer or experienced radio/TV technician for help.

Warning

Changes or modifications not expressly approved buy the manufacturer could void the user’s
authority to operate the equipment.