Soleusair Sg-was-06se Owner's Manual

Thank you for choosing a Soleus Air powered by Gree Air Conditioner. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new air conditioner.

For your own records, please attach a copy of your sales receipt to this manual. Also, write the store name/location, date purchased, and serial number below:

Store Name: ____________________________________________________

Location: ______________________________________________________

Date Purchased: _________________________________________________

Serial Number (located on back of unit): ______________________________

IMPORTANT SAFETY INSTRUCTIONS

Before installing and using your air conditioner, please read this owner’s manual carefully. Store this manual in a safe place for future reference. Your safety and the safety of others is very important to us. Please pay attention to all safety messages outlined in this owner’s manual.

WARNING: To reduce the risk of fire, electrical shock or injury when using your air conditioner, follow the following basic precautions:

• Plug into a grounded 3 prong outlet.

• Do not remove the ground prong.

• Do not use a plug adapter.

• Do not use an extension cord.

• Unplug the air conditioner before servicing

• Use two or more people to move and install the air

conditioner

This is a safety alert symbol. This symbol alerts you to potential hazards that can harm you or others or even cause death. All safety messages will directly follow the safety alert symbol and/or the words “DANGER” or “WARNING”.

All Safety messages alert you of potential hazards, how to reduce the chance of injury, and what can happen if instructions are not followed correctly.

Failure to immediately follow these instructions may cause serious injury or even death.

ELECTRICAL REQUIREMENTS

The electrical ratings for your air conditioner are listed on the model and serial number label located on the front left side of the unit (when facing the front).

Specific electrical requirements are listed in the chart below. Follow the requirements below for the type of plug on the power supply cord.

Power Supply Cord

Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove the ground prong. Do not use an adapter Do not use an extension cord. Failure to follow these instructions can result in death,

fire, or electrical shock

Wiring Requirements

• 115 volt (103.5 min.—126.5

max)

• 0-12 amps

• 15-amp time-delay fuse or

circuit breaker

• Use on single outlet circuit only

Recommended Ground Method

For your personal safety, this air conditioner must be grounded. This air conditioner is equipped with a 3 prong power supply cord with a grounded plug. To minimize the possibility of electrical shock, the cord must be plugged into a 3 prong outlet and grounded in accordance with all local codes and ordinances. If a 3 prong outlet is not available, it is the customer’s responsibility to have a properly grounded 3 prong outlet installed by a qualified electrician.

It is the customer’s responsibility:

• To contact a qualified electrician

• To assure that the electrical installation is adequate

and in conformance with the National Electrical Code,

Copies of the standards listed may be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, Massachusetts 02269

ANSI/NFPA 70 - latest edition, and all local codes and ordinances.

LCDI Power Cord and Plug

This air conditioner is equipped with an LCDI (Leakage Current Detection and Interruption) power cord and plug as required by US National Electric Code 440.65. This cord consists of a length of shielded flexible cord with no termination on the load side and a LCDI attachment plug on the line side.

The LCDI power cord and plug will remove the supply source via electrical disconnect (circuit trip) if the nominal current leakage between the cord shield and either load conductor exceeds a predetermined value. The cord will remain deenergized until the devise has been manually reset. This is intended to reduce the risk of a fire in the power cord or combustible materials nearby. The cord shields are not grounded and they must be considered a shock hazards if exposed. The cord shield must not be connected to ground or to any exposed metal.

The test and reset buttons on the LCDI Plug are used to check if the plug is functioning properly. To test the plug:

1. Plug power cord into a wall outlet

2. Press the TEST Button, the circuit should trip and cut all power to the air conditioner

3. Press the RESET button for use

If a test is performed and the indicator light remains ON, the current leakage has been detected. Do not use the air conditioner or attempt to reset the LCDI Plug. Contact Customer Service for troubleshooting recommendations.

PACKING LIST

Packing List:

• Window Air Conditioner

• Remote Control

• AAA Batteries (2)

• Top Mounting Rail

• Top Mounting Rail Seal Strip

• 2/5” Screw for Top Mounting Rail (4)

• Accordion Panels (Left & Right)

2/5”

Screw (4)

3/4”

Screw (

• Sash Lock (1)

• Window Sash Seal

• 3/4” Screw for Sash Lock & Accordion

• Foam Top Window Gasket

• Owner’s Manual

Panels (

Sash Lock (1)

SPECIFICATIONS

• Noise level is measured at a distance of 3.28 ft away from the front of the unit in cooling mode.

• Power consumption is measured when the fan runs at the highest speed setting.

• These specifications are for reference only. For actual data, please refer to the rating label on the unit.

Model SG-WAC-06SE

Power Supply (Ph/V/Hz) 1/115/60Hz

Dehumidifying Capacity (Pints/Day) 31.2

Rated Cooling Capacity (BTU/h) 6,000

Rated Heating Capacity (BTU/h) /

Cooling Power Input (Watts) 620

Heating Power Input (Watts) /

Rated Current Cooling (Amperage) 5.6

Rated Current Heating (Amperage) /

EER/C.O.P 9.7

Noise Level db (A) H/L 56/61

CFM 180

Design Pressure (PSIG) (H/L) /

Dimensions (W” x H” x D”) 18.59 x 12.75 x 15.72

Package Dimensions (W” x H” x D”) 21.84 x 14.19 x 17.91

Net/Gross Weight (Lbs) 46/54

SG-WAC-06ESE

1/115/60Hz

6,300

590

5.3

10.7

56/61

180

18.59 x 12.75 x 15.72

21.84 x 14.19 x 17.91

46/54

18.59 x 12.75 x 15.72

SG-WAC-08ESE

1/115/60Hz

40.8

8,000

740

7.1

10.8

59/63

200

21.84 x 14.19 x 17.91

49/56

Refrigerant Type R-410A R-410A

Refrigerant Charge (Oz) 12.35

R-410A

13.05

16.58

+ 9 hidden pages