Soleus Air KY-32U User Manual

KY-32U
Portable
Air Conditioner
User's Manual
- Cooling
- Dehumidifying
- Fan
TABLE OF CONTENTS
NAMES OF PARTS............................................................................................................... 2
INSTALLATION BEFORE USE................................................................................................ 3
CONTROL PANEL AND LCD DISPLAY .................................................................................... 5
CONTROL PANEL FUNCTIONS ............................................................................................. 6
OPERATION USING CONTROL PANEL .................................................................................... 7
CONDENSATE WATER DRAINAGE .......................................................................................... 11
MAINTENANCE ..................................................................................................................... 12
TROU BLESHOOTING ............................................................................................................ 14
TECHNICALSPECIFICATIONS ................................................................................................ 15
DISCLAIMER ........................................................................................................................ 15
CONTACT INFORMATION ...................................................................................................... 15
ELECTRIC PRINCIPLE DRAWING .......................................................................................... 16
WARRANTY ........................................................................................................................ 17
INTRODUCTION
Thank you for purchasing the Soleus Air KY32U portable air-conditioner. This unit is designed for
improving livingandworking comfort byprovidingcooling,dehumidilying andfanfunctionsonlywitha minimum installationrequired. With itswhisper quite operation and attractivedesign,you will enjoy the convenience and comfort that this unit provides formany years to come.
When operating as an air conditioner, this unit is designed for spot cooling or cooling for a room no
larger than 350 square feet with the standard ceiling height.
IMPORTANT SAFEGUARDS
Before you use your portable air conditioner, please read this operation manual carefully.
1)Neveruse or store gasoline or other flammable vapor or liquid near this unit.
2)Maintain at least 10" (25 CM) clearance space from this unit. Avoid air inlet oroutlet grilles from being covered or closed off.
3)The power supply must be properly grounded.
4)Do not use an adapter plug or extension cord.
5)Do not use theunit in the ilranediate surroundings of a bath, a shower or a swimming pool.
6) Do not letchildren play near this unit.
PACKAGE CONTAINS:
Mobile Air Conditioner Air Exhaust Duct
Exhaust Duct Window Kit Adapter Remote Controller
AAA Batteries (2) Window Kit - 3 Sliding Panels
Window Kit Fastener Screws (4) Continuous Drainage Tubing Pipe
Exhaust Outlet Wall Cover User Manual
-1-
NAMES OF PARTS
control panel
upper air outlet
Front View
Signal
Receptor
handle
lower air inlet grille
Exhaust Duct
Terminal
continuous drainage
water tank
BackView
upper air inlet
grill with filter
power cord
hot air exhaust
outlet
lower air
inlet grille
-2-
Unit Terminal
End
Exhaust Duct
Exhaust
Du_
Window Kit
Adaptor
WindowKits
INSTALLATION BEFORE USE
1) Condensate Water Tank Float Lid
You must install the water tank float lid before first use of the portable air conditioner following these procedures:
a) Hold the water tank and draw it out slowly.
b) Remove water tank float lid and packing material
from the water tank.
c) Insert the float lid into the water tank by inserting one side of the hinge into the
hinge holder on the water tank and then sliding the other side into its place. The
Floater
Water Tank
Fig.1 b)
-3-
water tank float lid should be able to move up and down freely after correct
installment.
d) Insert the complete water tank back to
the air conditioner unit.
2)
ExhaustDuct Fig. 1 c)
When you use the unit as an air conditioner, the hot exhaust air must be directed out of the rooln. The exhaust duct is used to allow the hot air out. DO NOT 1NSTALL ORUSE THE EXHAUST
DUCT WHEN THE UNIT IS OPERATED AS A DEHUMIDIFIER OR FAN.
a) Slid exhaust connector all the way down over
the discharge opening of the unit.
b) Mount the external end of the exhaust duct
onto a hole of 5 */4"(132 lnln) on the wall for optional wall hot air outlet installation, or
c.) Connect the window kit adaptor to the external end of the
exhaust duct for a window or sliding door hot air outlet
installation.
Window,
slidingdoor or
Wall
NOTE: In order to increase the efficiency, the exhaust duct should
be keep as short and straight as possible. The exhaust hose can be
cut shorter by unthreading either end of the exhaust duct counter clockwise. It is not recommended to increase the manufacturer's
length of the exhaust hose. This may impede or damage the unit.
Fig.2 a)
3) Window Kit Installation
Fig.2 b)-c)
a) Open window or sliding door for approximately 5 inches (130 ram)
b) Adjust the length of the window kit to the same length of the window or the sliding door.
Use all threepanels if necessary.
c) Use screws toaffix thewindow kit length.
d) Place the window kit to the window or sliding door. Close the window or door as Paras
itgoes.
e) Mount the window kit extension of the exhaust host onto the window kit.
-4-
Loading...
+ 14 hidden pages