Top Mount Stainless Steel Sink
Installation Instructions
Single Bowl Kitchen Sink 50/50 Double Bowl Kitchen Sink 60/40 Double Bowl Kitchen Sink
Before You Start
• Soleil recommends that all top mount sinks be installed by an experienced, professional installer.
• IMPORTANT: The cabinet must be installed, secured, plumb, and level. Failure of this step can
lead to product damage.
• Soleil top mount sinks should only be fastened to a solid surface countertop
(i.e. granite, Corian® or Silestone®) or laminate countertop.
• Soleil is not responsible for sink or countertop if damaged during installation.
Be sure to inspect the sink for damage prior to beginning installation.
• Metal edges may be sharp – use caution when handling.
• Follow all local plumbing and building codes.
Recommended Tools & Materials (Not Included)
Tape Measure
Safety Glasses
Painter’s Tape
Level
Framing Square
Pencil (not permanent marker)
Shims or Cabinet Fillers
Denatured Alcohol
Clamps
Construction Adhesive
Silicone Sealant
Screws (recommended by countertop manufacturer)
PAGE 1
Contact Soleil Sinks at (678) 445-4638 or visit www.soleilsinks.com. Copyright ©2017, Soleil Sink Company Inc. All rights reserved.
Top Mount Stainless Steel Sink
1 2
PREPARING THE COUNTERTOP CUTTING THE COUNTER
Installation Instructions
Position the sink (A) upside down on the countertop.
Trace completely around the edge of the sink (A).
Draw a line 5/16” inside of the outline of the sink.
WARNING: Always wear safety goggles and gloves
when using power tools to prevent personal injury.
Drill a pilot hole in all four corners of the inside line.
Use a saber saw or jig saw to cut on the inside line.
Place a support underneath the cutout portion of the
countertop to prevent it from falling during cutting.
3
INSTALLING THE SINK
Apply silicone sealant (not included) around the cutout
on the countertop surface.
Carefully lower the sink (A) into the cutout in the countertop.
Preassemble the clamps and screws (AA).
From the underside - place the clamp (AA) in the center along
each side and hand tighten to hold sink in place. Fasten the
remaining clamps (AA) along the edges and space them
approximately 3 in. from each end, and equally along the
front, back and sides. For countertops thicker than 3/4 in.,
space them up to 1-1/2 in. apart.
From the top - check the seal between the sink (A) edge and
countertop. Adjust clamps (AA) if necessary.
Lightly tighten clamps (AA) evenly with a screw driver until the
sink is perfectly tight to the countertop. Do not over tighten.
Wipe away any excess sealant with a rag.
Contact Soleil Sinks at (678) 445-4638 or visit www.soleilsinks.com. Copyright ©2017, Soleil Sink Company Inc. All rights reserved.
PAGE 2
Loading...