Solar Trend 03091 User guide

Page 1

User manual Power set 90W - 230V item no. 03091

1. Introduction

Dear customer. Thank you for purchasing one of our products. This product corresponds to the applicable European directives and National regulations. Conformity has been proven. Relevant declarations and documents are deposited at the manufacturer.

2. Safety note

Failure to observe these instructions will render the warranty void. We assume no liability for consequential damages! We will assume no liability for material damage or personal injury resulting from inappropriate handling or non-compliance with the safety precautions. In such cases, any warranty shall be void. For safety reasons (CE), unauthorised alterations or changes to the product are not permitted. This product is not a toy. Keep out of children's reach.

3. Application, setup and connection as directed

The product is designed for outdoor use and intended for gaining solar power.

Please make sure that the polarity is correct during setup. Please refer to the identification markings PLUS (+) and MINUS (-)!

The following sketch illustrates the connection of all components to the charge / discharge regulator (item no. 03155):

4. Initial start-up

1. Carefully unpack all parts.

2. Position the three solar modules (item no.

03150) in a suitable place exposed to direct sunlight. All cables must be laid accurately and safely.

3. Connect the battery connection cable (item no.

80083) of a 12V battery (such a rechargeable battery is not included in the delivery) to the two middle connections. Connect the lead marked with PLUS (+) to "B+" and the lead marked with MINUS (-) to "B-".

4. Use the 10cm cable with clamp (item no.

80084) to connect the three solar modules to the two left connections. Then connect the lead marked with PLUS (+) to "S+" and the lead marked with MINUS (-) to "S-".

Connect the appliances (load), e. g. LED flash

5. light (item no. 03100) to the two right connections. Then connect the lead marked with PLUS (+) to "L+" and the lead marked with MINUS (-) to "L-".

4. Continuation initial start-up

6. Purchase a suitable 12V rechargeable battery with sufficient capacity (Ah) to allow a greater energy storage. A rechargeable battery with approx. 107Ah is recommendable. Special solar batteries are offered under www.sued-solar.de.

7. Do not switch on the appliances (load) until the solar module has charged the 12V battery sufficiently.

8. Connect the voltage converter (12V / 230V) directly to the 12V battery (see separate instructions for voltage converter).

REV-2-19-01-12

Page 2

User manual Power set 90W - 230V item no. 03091

5. Care, maintenance and malfunctions

Clean the product with a clean dry cloth only. Avoid polarity reversal, otherwise the battery will not be charged. In case of reverse polarity, immediately adjust the connecting leads of the solar module!

6. Scope of delivery:

1. 3 x solar module 12V / 30W (item no. 03150)

2. 1 x charge / discharge regulator (item no. 03155)

3. 1 x battery connecting cable (item no. 80083)

4. 1 x 10cm cable with clamp (item no. 80084)

5. 1 x LED flash light with 5m cable set (item no. 03100)

6. 1 x user manual

7. 1 x voltage converter 12V / 230V 600W

7. Technical data:

One solar module:

Nominal voltage : 12V DC Nominal capacity : 30W peak

Charge regulator:

Temperature range : - 20°C to + 50°C

LED light:

Overall weight : gross approx.15.0kg / net approx.14.0kg Subject to technical modifications

Further details, values and data can be taken from the type label of the solar modules.

Calculating operating hours using the example of a 6W LED flash light: Summer half-year: Average of 5 hours of sunshine at 30W module power x 3 = 450 watt-hours (Wh).

Example 1: Using one 6W light = approx. 75 operating hours. Example 2: Using four 6W lights = approx. 18 operating hours each. Therefore the 12V battery requires a capacity of 45Ah minimum. A higher capacity allows several daily charges at 450Wh each to be stored. Winter half-year: Average of 2 hours of sunshine at 30W module power x 3 = 180 watt-hours (Wh). Example 1: Using one 6W light = approx. 30 operating hours. Example 2: Using four 6W lights = approx. 7.5 operating hours each.

Further accessories such as solar modules, holders, solar batteries, LED lights and voltage converters from 12 to 230V can be found under www.sued-solar.de including for example.

Aluminium module holder (item no. 03170) Solar battery 36Ah (item no. 03184) LED flash light (item no. 03100)

8. Warranty

: Monocrystalline glass module with aluminium frame (L: 540mm, W: 435mm, H: 30mm) with 5 metre cable

set

12V DC, max. 10 A charge and discharge current, excess charge and deep discharge protection

12V DC, 27 SMD-LEDs approx. 5000K, approx. 6W

Warranty service is provided by the retailer from which you have purchased the product. Warranty service is provided on presentation of the product invoice or receipt.

9. Disposal instructions

Electric appliances must not be disposed of with the regular household garbage. The customer is legally obligated to return these appliances, e.g. at public collecting points or shops where such appliances are sold.

REV-2-19-01-12

Solar Trend 03091 User guide

Specifications and Main Features

Frequently Asked Questions

User Manual