
Solar pump set CAPRI Article No. 01244
Take all parts carefull y out of the box. Mak e sure that you ha ve removed all part s before you dispose t he pack-
Fix the ground spike to the aluminium frame of the solar module and install it in a sunny place.
Assemble the standpipe out of the multiple tubes and nozzle set and sl ide the LED ring f or the lighting over the
Lay out the cables betwee n the solar module and the c onnection box being care ful to avoid trip hazzar ds. Plug
Press the sensor button “EIN” (“ON”) at the connection box to activate t he pump into the Solar mode. Solar
When the battery is low a red LED will blink.
By pressing the se nsor butt on durin g a sun ny day you will tur n off the pump and allow th e energ y to ch arge the
When the integrated bat tery is fully charge d, by pressing the sens or button (batter y mode) the p ump will operate
1. Introduction
Thank you for purchasing one of our products. This product complies with the
requirements of the applicable European directives and national regulations. Its
conformity is proven, andthe corresponding declarations and documents are
available at the manufacturer.
2. Safety notice
Damages arising from non-observance of these operating instruct ions in val id ate
the warranty! No liability is accepted for any consequential damages! We do not
accept any liability for any material or personal damage arising from improper
use or non-observance of safety notices. Such cases invalidate the warranty. Arbitrary or unauthorised alterations or
modifications are not permissible for safety reasons (CE). Service and maintenance may be performed by qualified
personnel only. This product is not a toy. Keep it out of reach of children.
3. Appropriate Use
The solar pump set CAPRI is designed for outdoor use.
4. Commissioning
aging material in an environmentally friendly way.
Treat the solar module very carefully. A broken solar module is not subject to a warranty claim.
Ideally facing south.
top of the standpipe. Select and fit t he multi-jet or the single-jet fountain hea d. Fit the sta ndpipe with the LED
ring and the fountain head onto the pump and then place into the water.
in all cables to t he c o nnection box at t he r ear of the solar module. When the sun shines on the solar module, the
integrated battery is charged.
mode means that the pump will operate dai ly when e nough sunlight falls on the solar module. - Attention: The
pump will not operate when the sky is cloudy or in the dark at night.
When the battery is sufficiently charged (by sunlight on the solar module), an orange LED will blink.
When the battery is fully charged, a green LED will blink.
integrated battery.
in dull weather or at night.
At night the LED ring will automatically turn on offering light to your fountain.
After approximately 6 hours working in battery mode the pum p and the LED ring will switch off and the s ystem
returns to daily solar mode.
Please pay attention that during the operat ion splashing water can ca use damages to the subsoil a nd the closer environment of the founta in. O n ly u s e the pump kit in sui table places . W e do not ac ce pt an y liabilit y for dam ages which occ ur
through spraying or running out water.
1. Care, maintenance and malfunction
Only c lean the prod uct with a damp cloth. If the pum p fails to operate f irst check the position of the solar module t o ensure it receives sufficient sunlight. T he pump will onl y operate when it has s uffic ient power from either direct solar ener gy
or stored energy in the bat tery. On dull days the stored s olar energy from the battery is possibly not enough to op erate
the pump.
Distribution by Süd Solar GmbH, Max-Eyth-Str 6, 71732 Tamm (Germany)
Copyright © Süd Solar GmbH, 2015, subject to modications.
www.sued-solar.de

Solar pump set CAPRI Article No. 01244
Solar module with connection box and integrated battery
Ground spike set, series of three (1 x angle holder, 1 x earth spike, 1 x extension)
Sprinkler head kit (3 x pipe section, 1 x multiple fountain, 1 x mushroom shaped nozzle)
Silicon cover crystalline, 9 Volt, 5 Watt (max.)
Flow rate 450 liters per hour maximum, height of the fountain up to 80 cm
(dependent on battery charging and the used nozzle)
approx. 5 meters feed cable
4 white LED with ring autamtically switching on at night if the pump is activated
7.2Volt, 2000mAh, Lithium
For cleaning, the filter box of the pump can be opened:
Pull off the cap at the fr ont of the pump. Take out the foam filter element. Clean it with clear water. Rem ove the cover
from the pump impellor and magnetic rotor. Clean thoroughly and then reassemble in reverse order.
The 7.2Volt lithium battery installed in the battery box is changea ble. If needed, o pen the 4 screws at the rear of the solar
module an d change f or a sim ilar battery. Reassem ble in re verse ord er mak ing sure th e seal is in place to avoid m oisture
entering the battery box.
Attention! During the winter and transition periods with frost the pump must be completely taken out
of the water, cleaned and stored in a frost protected dry place. In order to assure a longer durability of
the solar module we recommend to store it with the pump.
2. Contents
3. Technical Data
4. Warranty
Warranty service is offered by the authorized dealer where the product has been purchased.
Warranty service is offered under presentation of the invoice or receipt for the product.
5. Disposal of batteries
Batteries must not be disposed into the ordinary rubbish.
The user is engaged by law to return batteries after use, for example to public collecting
points or to the shops where batteries are sold.
6. Disposal advice
Disposal of electronic devices must not be with the consumer waste. The user is legally responsible
to return these goods after use to an appropriate public collecting point or to places where such
devices are sold for recycling.
Distribution by Süd Solar GmbH, Max-Eyth-Str 6, 71732 Tamm (Germany)
Copyright © Süd Solar GmbH, 2015, subject to modications.
www.sued-solar.de