Page 1
WALL MOUNTING KIT
WB1C
A
3/8" FLAT WASHER
3/8" X 1" LG. BOLT
A
A
3/8" FLAT WASHER
3/8" LOCK WASHER
3/8" NUT
A
B
Technical Support
(800) 377-4384 • (847) 268-6651
solahd.technicalservices@emerson.com
www.solahd.com
While every precaution has been taken to ensure accuracy and completeness in this manual, Appleton Grp LLC
d/b/a Appleton Group assumes no responsibility, and disclaims all liability for damages resulting from use of this
information or for any errors or omissions. Specications are subject to change without notice.
P/N: A272-285 Rev. 0 02/2016
© 2016 Appleton Grp LLC d/b/a
Appleton Group. All rights reserved.
Installation Instructions
1. Remove (2) sheet metal screws from top cover (rear) at position A. Re-Drill existing holes at
positon A on top cover and postion A on each side panel to accommodate 3/8” bolts.
2. Replace top cover and then remove rear panel to gain access to interior. Secure top cover to
side panel with 3/8” bolts and hardware as shown.
3. At position B, remove 3/8” hardware on (1) side only and install mounting bracket with existing
hardware as shown. Repeat procedure on other side. When complete, replace rear panel. Unit is
now ready for wall mounting.
NOTE: Maximum weight for wall mounting should not exceed 500 lbs.
Loading...