Power Supply Accessories
Panel Mount Brackets Installation
1. Remove the M3X6 mm Phillips Screws, shoulder screw, plastic slide, spring
and C-Insert from the DIN Brackets.
Panel Mount Brackets Installation Manual
SDN-PMBRK3
7 9
83472 00651
P/N: A272-289 REV. 1 (07/16)
©2016 Appleton Grp LLC d/b/a Appleton Group
All rights reserved. Specifications
subject to change without notice.
CAUTION:
Risk of Electric Shock and Personal Injury
Ensure unit is disconnected from all power
sources prior to replacing brackets.
This set consists of two panel mount brackets, which replace the existing two
DIN mounting brackets at the back of the unit.
FOR USE WITH:
SDN 5-24-100C
SDN 10-24-100C
SDN 40-24-100C
SDN 10-24-480C
SDN 2X20RED
CHASSIS MOUNTING
Spring
C-Insert
M3X6 mm
Phillips Screw
DIN Bracket
Shoulder screw
Plastic slide
2. Retain and slide back the two DIN brackets to use as a guide for the installation
of the panel mount brackets.
DIN Bracket
INCLUDED:
Two M3x8 mm phillips screws
Two brackets
Two lock washers
NOT INCLUDED:
Four 8-32 x 1/2” screws for mounting unit to panel
Four 8-32 flat washers
Dimensions in Inches (Millimeters)
1.47 (37.3)
1.65 (41.9)
0.87 (22.1)
Top View 3D View
0.60 (15.2)
3. Push and slide the panel mount brackets on the top of DIN bracket and secure
with M3X8 mm Phillips Screw and lock washer (use 7kgf torque).
Panel Mount
Bracket
DIN Bracket
M3X8 mm
Phillips Screw
Loading...