Caution
Industrial Control Transformers
Dimensions in Inches
Panel Mount Brackets Installation Manual
SDN-PMBRK2
P/N: 272-38176-10
REV. 05 (05/16)
©2016 Appleton Grp LLC d/b/a Appleton Group
All rights reserved. Specifications
subject to change without notice.
Make sure all power is off
before any wiring is started.
Chassis Mounting
The Sola SDN/SLR/STV can also be screw mounted by means of the
panel mount bracket set SDN-PMBRK2.
This set consists of two steel brackets, which replace the existing two
DIN mounting brackets at the back of the unit.
Included:
Two lock washers
Not Included:
existing bracket)
Four 8-32 x .5” screws for mounting unit to panel
Four 8-32 flat washers
Two brackets
Two M3 x 6mm screws (reused after removing
Exchanging the Brackets
a. At the unit:
1. Remove the screw from
the DIN bracket. (Retain
screws to use on panel
mount bracket).
2. Pull the bracket
outwards
to remove.
b. Push the SDN-PMBRK2
bracket into the groove as far
as possible. Slide upwards and
secure with screw and lock washer.
Note the orientation:
The bracket fits into the
groove only as shown here.
Loading...