Snugpak Scorpion 2 User Manual

Assembly Instructions for SCORPION 2

™

SCORPION 2

Fly-First Pitch

Type Design

WARNING:

KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC. THIS TENT

MEETS THE FLAMMABILITY REQUIREMENTS

OF CPAI-84. THE FABRIC MAY BURN IF LEFT

IN CONTINOUS CONTACT WITH ANY FLAME

SOURCE. THE APPLICATION OF ANY

FOREIGN SUBSTANCE TO THE TENT FABRIC

MAY RENDER THE FLAME-RESISTANT

PROPERTIES INEFFECTIVE.

x2

™

Black Tip (Angled)

GreyTip (Straight)

x1

Alloy Stakes

x16

1

Pole Placement

1. Insert one Black Tip Angled
Pole with Black section to
Black trim edging.

2. Insert the other Black Tip
Angled Pole with Black
section to Black trim edging.

3. Insert the Grey Tip Straight
Pole with Grey section to
Grey trim edging.

Additional Ultralight Alloy Original Stakes can be purchased separately. Aftermarket stakes can also be
used with this tent whether it be with the loop webbing or through the secondary grommet available.

3

2

2 3

1

a. Take out the Fly (Outer Tent ) and unfold and spread it out.
b. Assemble Pole Sections - Carefully unfold the pole sections and allow them to slide
together by inserting within one another.
c. Insert the poles into the pole sleeve channels
(we

recommend to always push poles through, do not pull through sleeve channels).

Waterloo Mills, Howden Road

Tel: [phone] Fax: [phone]

Snugpak LTD

Silsden, West Yorkshire

BD20 0HA, England

www.SNUGPAK.com

Snugpak® products are exclusively

distributed in North & South America by:

Proforce Equipment, Inc.

3230 Executive Way - Miramar, FL 33025

www.ProforceEquipment.com

Ph: 305.436.7984 / 800.259.5962

www.SNUGPAKUSA.com

a. Insert the tent pole ends into the grommets in the corresponding webbing straps. Once

b. The pole channels and poles should intersect for proper form, support and structure.
c. Now unzip the door and open it to gain access to the inside of the Fly (Outer Tent ).
d. Take the Inner Tent and line up the Door and vents and start to attach the toggle to the
corresponding supporting ring on the Fly (recommend one start from the back and
work their way out from the main door and vestibule).

a. Once the Inner Tent is connected with the Fly by all the Toggle and Ring attachments,
then click all the side release buckles together.
b. Then take the Ultralight Alloy Stakes that came with the tent and run them through the
loop of the webbing with the grommets and stake down accordingly.
c. Once the tent is Staked out / down then adjust the tension of the Side Release buckles
webbing of the Inner tent to achieve the desired result
(

Note: there is a secondary grommet visible on webbing strap for different stakes if needed).