Snapper MGt1800G User Manual

Specifications and Main Features

  • Model: MGTI800G
  • Type: Robotics Lawn Tractor
  • Engine: Twin cylinder
  • Recommended Fuel: Gasoline Unleaded 87 octane and above
  • Fuel Capaciy: 31 liters
  • Hydraulic Oil: Textron II Hyd oil
  • Engine Oil: Winter 5W30 and Summer 10W30
  • Transmission: Power 4
  • Brake Type Two: Brake types: Two rear wheel brakes which both are independently controlled
  • Approximate Speed:
  • 1st Gear: 0 - 1.5 km/hr
  • 2nd Gear: 0 - 4.5 km/hr
  • 3rd Gear: 0 - 6.6 km/hr
  • 4th Gear: 0 - 12 km/hr
  • Reverse: 0 - 6 km/hr

-Cpclutchedisc: Clutch type used engine disc or and a pedal used in interaction ss

  • PTO: Usunt Tespto Gym Electric
  • Dimensions: Refer to Section “Tractor Specifications” for detailed dimensions
  • Attachments Compatibility: Also fits the auxiliary hydraulic lift, the rear towbar. Optionally three point hitch, front

Frequently Asked Questions

  • Q: What type of fuel should be used for the MGTI800G?

A: Unleaded gasoline with minimum octane rating of 87.

  • Q: How often should the oil be changed?

A: Change oil and filter after first use for five hours then every after hundred use hours

  • Q: Is it possible for me to use the tractor on slopes or an inclined surface?

A: Avoid performing tractor operations on any slopes that are more than fourteen degrees. However, exercise caution in slopes that are more than ten degrees.

  • Q: What type of maintenance would the hydraulic system require?

A: Every twenty-five hours of running the tractor, check for any leaks in the hydraulic hoses and their fittings. It is recommended to store the hydraulic oil around three inches below the hydraulic tank’s top.

  • Q: If I intend to store the tractor for a longer period, do You require doing or applying some procedures to it?

A: First, you will need to change the oil, run the engine till it has finished the gasoline. General maintenance should be done as in the manual.

  • Q: In the case that the engine fails to start what should I do?

A: You will first need to check if the correct starting procedure is followed and ascertain the battery charge. The operator, the depression of the clutch pedal and the position of the blade switch being ‘off’ should accompany each other.

User Manual

Page 1
Snapper MGt1800G User Manual
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
Page 12
Page 13
Page 14
Page 15
Page 16
Page 17
Page 18
Page 19
Page 20
Page 21
Page 22
Page 23
Page 24
Page 25
Page 26
Page 27
Page 28
Page 29
Page 30
Page 31
Page 32
Page 33
Page 34
Page 35
Page 36
Page 37
Page 38
Page 39
Page 40
Page 41
Page 42
Page 43
Page 44
Page 45
Page 46
Page 47
Page 48
Page 49
Page 50
Page 51
Page 52
Page 53
Page 54
Page 55
Page 56
Page 57
Page 58
Page 59
Page 60
Page 61
Page 62
Page 63
Page 64
Page 65
Page 66
Page 67
Page 68
Page 69
Page 70
Page 71
Loading...