Snapper FC836, FC1242 User Manual
Specifications and Main Features
- Manufacturer: Briggs & Stratton ( Refer to engine manual for details on the model and its specifications)
- Fuel Tank: 2 gallons
- Speed:
- Gear 1 = 3 kph
- Gear 2 = 3.2 kph
- Gear 3 = 4 kph
- Gear 4 = 4.5 kph
- Gear 5 = 5.8 kph
- Reverse: 2.4 kph
- Controls:
- clutch: Clutch/Wheel Brake Combo (Right Side)
- Brake: 7 ‘ diameter ‘ type one way drive axle.
- Parking Brake: Hand lever fitted on the brake pedals.
- Gear Selector: Cable Type Switched October, located on right hand console.
- Mower Drive: Lever to the left of the seat of the mower
- Mower Height: 5 positions of pins made on a mower deck
- Throttle Control: Engine speed and choke control, combined (left hand console)
- Starter: Key switch and electric start.
- Steering: Each rear wheel is operated by its own stainless steel control cable.
- Turning Radius: 6 inches
- Dimensions:
- Steering Wheel Height: 42 inches
- Steering Column Height: 30.5 inches
- Engine Cover Height: 24.25 inches
- Seat Height: 34 inches
- Overall Length 82 Inches with 42” Mower
- Overall length 83.75 inches with 36” Mower
- Overall Length of Rider: 64 Inches
- Overall Dimensions with P42 Mower: 57.5 inche
- Overall Dimensions with P36 Mower: 45.5 inch
- With Kontak Mower: 36 inch
- With Kontak Mower: 28 inch
- Weight: 490 lb mowers p42
- Weight: 432 lb with mowers p36
- Rear Tires: 4.1/3.5-4 Pneumatic, 10 psi
- Front Tires: 15 x 6-6.00 Pneumatic, 10 psi
Frequently Asked Questions
Q1: Is a Vanguard Riding Mower equipped with Briggs & Stratton Engine?
Yes, a Vanguard Riding Mower has Briggs & Stratton Engine installed.
Q2: How many gallons can be filled in Vanguard Riding Mower when full?
A Riding Mower can be filled with gasoline for approximately two gallons.
Q3: How many speeds are there in the forward direction and backward direction on the Riding Mower?
The Riding Mower can go 5 different speeds in the forward direction and 1 in the rear.
Q4: What devices are present in the Riding Mower to increase the safety of the user?
There are various harness safety interlocks present that are used to disengage the engine if the seat is vacated by the operator.
Q5: What is the procedure for altering the cutting height of the mower?
A5: To adjust the cutting height, first remove four clips , then shift the pins in the positions of other holes. This is to ensure an even cut because the pins must be inserted in appropriate holes at all four positions.
Q6: What steps are required if the engine fails to crank?
A6: For the engine not cranking, it is required to confirm that the gear shift is on neutral, the mower engagement lever has been switched off, and now check for presence of fuel in the tanks. If all these fail, look at the battery and its connections.
User Manual
Loading...