Snapper 1694946 User Manual

Installation Instructions

Front Counter Weight Kit

Mfg. No. 1694946

Installation

“J”-HOOK REMOVAL

1. Remove Mower Deck. See Operator’s Manual MOWER DECK REMOVAL & INSTALLATION.

2. Remove and retain 7/16-14 x 2 capscrews (A, Figure

2) and 7/16-14 locknuts (B) from front axle (D). Discard “J”-hook (C).

For the LT-200 Series

Figure 1. Contents

Kit Contents:

Ref. Part No. Qty. Description

1 1960074 2 Clips, Hair Pin 2 1732995A 1 Bracket 3 1715758 2 Rods 4 1732993A 1 Counter Weight

This kit is to install a front counter weight onto a LT-200 Series Lawn Tractor.

Before beginning any service work turn off the PTO, set the parking brake, turn off the ignition, and disconnect the spark plug wire(s).

WARNING

Figure 2. Remove “J”-Hook A. Capscrews, 7/16-14 x 2 B. Locknut, Flange, 7/16-14 C. “J”- Hook D. Front Axle

Installation Instructions Rear Weight Carrier Kit

Form No. 1733188-00

Rev. 06/2005

TP 200-4306-00-AT-N

Snapper, INC.

535 Macon Street McDonough, GA 30253 USA

BRACKET INSTALLATION

1. Install the new bracket (C, Figure 3) to front axle (D) securing with existing 7/16-14 capscrews (A) and existing 7/16-14 locknuts (B).

WEIGHT AND DECK INSTALLATION

1. Use one of the rods (A, Figure 5) in the lower hole of bracket (D) to Install Mower Deck. See Operator’s Manual MOWER DECK REMOVAL & INSTALLATION. Secure rod (A) with clip (B).

2. Insert one of the rods (A) through the hitch (D) and weight (C). Secure rod (A) with clip (B).

Figure 3. Install Front Weight Carrier Bracket A. Capscrews, 7/16-14 x 2 (Existing) B. Locknut, Flange, 7/16-14 (Existing) C. Bracket, Front Weight Carrier (New) D. Front Axle (Existing)

Figure 4. Remove and Discard Rod & Clip A. Clip, Safety Pin B. Rod C. Hitch, Deck

Figure 5. Rods and Weight A. Rods B. Clip, Hair Pin C. Weight D. Bracket