SNAIGE CD480 Instructions For Use Manual
Vertical display cooler
Instructions for Use
SAFETY INSTRUCTIONS
Carefully read the Instruction manual! If instructions are not followed, there is a
risk of injury, damage of the appliance and loss of the right to free warranty
service. We recommend to keep the Instruction manual the whole time you have
the appliance. When you sell the appliance pass the Instruction manual to the
new owner of the appliance.
WARNING!
Do not cover the ventilation holes at the top and on the sides of the
appliance.
Do not use any mechanical means or electrical devices to hasten the thawing
process when cleaning the freezer compartment.
Do not use electrical appliances inside the food storage compartments of the
appliance, unless they are of the type recommended by the manufacturer.
If the supply cord is damaged it must be replaced by the manufacturer,
manufacturer service agent or a similarly qualified person, in order to avoid a
hazard.
Disposal of the appliance should be according to national rules.
Do not damage the appliance refrigeration system. It contains the refrigerant
gas R600a. If the refrigeration system is damaged:
• Do not use any open flame.
• Avoid sparks ― do not turn on any electrical appliances or
lighting fixtures.
• Immediately ventilate the room.
The appliance should be used only for storing foodstuffs.
This appliance is not designed for the storage of explosive substances such
as aerosol cans with a flammable propellant.
It is prohibited to store petrol and other flammable liquids near the appliance.
CONNECTION TO THE MAINS
The appliance should only be connected to an earthed socket installed in
accordance with the regulations. Make sure that the supply voltage
corresponds with the voltage marked on the rating label. This product
complies with all binding CE labelling directives.. The earthed electrical
socket by which the appliance is connected to the mains should be in an
accessible place.
1
IF THE APPLIANCE IS PRODUCED WITH THE SPECIAL SUPPLY CORD
IT CAN BE EXCHANGED ONLY BY THE SAME SPECIAL SUPPLY CORD
PROVIDED BY THE MANUFACTURER.
TO AVOID HAZARDS, DAMAGED POWER SUPPLY CORDS SHOULD BE
REPLACED ONLY BY THE MANUFACTURER, A MAINTENANCE
TECHNICIAN, OR A PERSON WITH AN EQUIVALENT QUALIFICATION.
DO NOT USE extension cords or connectors (adapters) or couplers.
The frequency and power of the electricity supply in your house must
conform to the general data parameters of the appliance as it is shown in the
product label.
When positioning the appliance, be careful that the electrical cord isn’t
squeezed in order to avoid its damage. Do not store heavy objects such as
cooling devices or other devices next the appliance in such a way that they
could squeeze and damage the electrical cord. This can cause a short circuit
and a fire.
Make sure that the plug of the electrical cord is not squeezed by the back
wall of the appliance or otherwise damaged.
A damaged plug can be the cause of a fire!
• If the appliance is unplugged (for cleaning, moving to another place, etc.), it
may be repeatedly SWITCHED ON AFTER 15 MIN.
• It is forbidden to use a technically damaged appliance.
• Do not place any switched on electrical devices (such as microwave ovens,
hair dryers, irons, electric kettles or other electrical devices) on top of the
appliance because this may cause ignition of plastic parts.
• Do not place any dishes with liquids on top of the appliance and do not keep
flowers in vases or other liquid-filled vessels on the appliance.
IF THE APPLIANCE IS OUT OF ORDER AND IT IS NOT POSSIBLE TO
REPAIR IT BY MEANS OF GIVEN RECOMMENDATIONS, UNPLUG IT,
OPEN THE DOORS AND CALL THE SERVICE EXPERT. ONLY A
SERVICE REPRESENTATIVE CAN REMEDY ALL TECHNICAL OR
CONSTRUCTION FAULTS.
ENVIRONMENTAL PROTECTION INFORMATION
This symbol indicates that once the appliance is no longer needed, it cannot
be disposed together with other miscellaneous municipal waste. It should be
collected and eliminated separately, i.e. in containers specially marked with
this symbol in large-dimension rubbish collection areas. Full information on
where to submit the old appliance safety can be obtained from local
2
government authorities, the shop where you bought the appliance or the
manufacturer’s representatives.
If you decided to scrap the appliance, make it impossible to use in order to prevent
possible misadventure. Pull out the electric plug from the electricity supply socket and
then cut off the cord. Tear off the gasket. Break the door lock if any.
WARNING! Do not dismantle the appliance yourself. Pass it on to recycling
companies.
TRANSPORT
THE MANUFACTURER WILL NOT BE RESPONSIBLE FOR ANY DAMAGE OF THE
APPLIANCE THAT RESULTS FROM NON-COMPLIANCE WITH THE
INSTRUCTIONS FOR TRANSPORTATION.
• The appliance should be transported only in the vertical position.
• When being transported, the appliance should be protected from atmospheric
conditions (rain, snow, dampness).
• The appliance should be firmly secured in place while being transported, to avoid
slippage or any shocks in the transport vehicle.
• If the appliance was transported not vertically, it may be connected to the
mains after 4 hours at least. If this is not done, the appliance compressor
may fail.
GENERAL INFORMATION
The cooling appliance is a vertical refrigerator cooler with a door made of glass,
designed for the short-term storage and display of fresh food products and for chilling
drinks. The cooling device can be used in catering establishments, shops, bars and
clubs. This cooling device is intended for commercial use only!
THE APPLIANCE IS ECOLOGICALLY CLEAN, CONTAINING NO MATERIALS HARMFUL TO
THE OZONE LAYER: the refrigerant used is R600a, the foaming agent used for the
appliance insulation is cyclopentane C5H10.
THE MANUFACTURER GUARANTEES RELIABLE OPERATION OF THE REFRIGERATOR
WHEN THE AMBIENT TEMPERATURE IS +16 TO +32 DEGREES CELSIUS AND THE
RELATIVE AIR HUMIDITY NOT GREATER THAN 60 PER CENT.
The appliance climate class is 3.
Inside temperature class – S (from –2 °C to +14 °C)
3
Loading...