SM Pro SCR-15sm Installation Manual

sm

Installation Guide

SCR-15sm Installation Guide Rev A 121014

SCR-15sm

STEP 1  ATTACH HF UNIT TO LF UNIT

1a. Remove four screws on top surface of LF Unit

1b. Place HF Unit on LF Unit, aligning front-to-back, side-to-side

SCR-15sm

1c. Reinstall screws fastening HF Unit to LF Unit

STEP 2  CONNECT LF UNIT

3a. Connect loudspeaker wires from amplier LF channel output to either binding post pair on
the LF unit. Be sure to observe correct polarity.

Connect To Woofer (LF) Amplifier Channel Negative Output

Connect To Woofer (LF) Amplifier Channel Positive Output

LF

Note: The two pairs of binding posts
on the LF unit are wired together inside
the loudspeaker, therefore, either set
may be used, or you may use all four
to increase current capability by using
four wires from your amplifer. If you
use four, connect the two negative
wires together and the two positive
wires together at the amplier end and
then to the corresponding amplier
output terminal.

CAUTION: DO NOT CONNECT NEGA­TIVE AND POSITIVE WIRES TOGETHER.
AMPLIFIER DAMAGE WILL RESULT.

SCR-15sm

STEP 3  CONNECT HF DRIVER

4a. Connect loudspeaker wires from amplier HF channel output directly to the binding post
pair on the HF driver. Be sure to observe correct polarity.

Connect To Tweeter (HF) Amplifier Channel Negative Output

HF

Connect To Tweeter (HF) Amplifier Channel Positive Output

Professional Home Cinema, LLC

dba Pro Audio Technology

5445 Oceanus Drive, Suite 110

Huntington Beach, CA 92649

Tel: [phone] Tel: [phone]

Fax: [phone]

SCR-15sm