Rhein Tech Laboratories Client: Mobile Communication Technologies, Inc.
360 Herndon Parkway Model: BST850
Suite 1400 Standards: FCC Part 22 & IC RSS-131
Herndon, VA 20170 FCC ID: OW5BST850
http://www.rheintech.com
RTL WO: 2003050
APPENDIX H: USER’S MANUAL
Please see the following pages.
Page 70 of 62
Dual Band Glass
Mount 15” Antenna
AC/DC Power Supply
(Optional)Allows Use of
Booster In Home Or Office
Adapter Cables
(Order Separately)
SmoothTalker
Dual Band Mag
Mount Antenna
Maximum Power
Dual Band Glass
Mag Antenna
(Optional)
Dual Band Glass
Mount 4” Antenna
User Instruction Manual
Model BST850
Maximum Power
Mobile Communication Technologies
Contact Us At
SmoothTalker
MCT
Cellular Band Booster Amplifier
GSM/GPRS/EDGE/TDMA
Specifications: Model:BST850
Frequency Range (Mhz)
Uplink 824-849 1850-1910
Downlink 869-894 1930-1990
Output Power max 3 Watt Antenna Gain Only
DC Input Power Stand By DC 12V/0.2A Max
In Use DC12V/1.6A Max
RFConnector MCT-Male
Weight 535g
Dimensions 222 x 82 x 25mm
www.smoothtalker .com
www.smoothtalker .com
User Instructions
Typical Car Installation
Cellular
Phone
Hands Free
In-car Kit
Antenna
Car Kit Ant Out
Cellular
Antenna
Adapter
Car
Booster
Car
Antenna
Car Booster Instructions:
1
) Instructions for m
**This device should be installed with the antenna supplied. It is required
that the antenna is mounted is a suitable location which is a minimum
distance of 20cm(8 inches)away from the user or nearby persons in order
to comply with FCC rules concerning MPE (Maximum Permissible Exposure)
safety limits**
Magnetic Mount: Place centered, only on vehicle roof or 8 inches(20cm)
away from any vehicle occupant or nearby persons.
Glass mount: The antenna base should be placed on the front or rear windshield
and centered as close to the vehicle roof as possible. It should be positioned to
provide a minimum distance of 8 inches (20 cm) from any of the vehicle occupants
or nearby persons. Run the co-ax cable along the head liner or along the floor
under the carpet and bring up to the position of the booster.
Connect co-ax cable to side of booster marked “Antenna”.
Trunk mount: When mounting on trunk the antenna should be placed in the center
of the trunk closest to the rear windshield of the vehicle.
3) Connect the 100cm cable from cell phone to side of booster marked
“Signal Adapter”.
When using with Cell Phone :connect cell phone adapter cable from
cell phone to 100cm cable.
When using with Car Kit: connect Car Kit antenna out, to 100cm cable.
) Place the Booster in a suitable location under the dashboard and
plug in power cord to cigarette lighter socket of vehicle.
2 ounting antenna to vehicle:
It should be positioned to
provide a minimum distance of 8 inches (20 cm) from any of the vehicle occupants
or nearby persons.
4) Tighten all connections securely and move the switch located at the
side of the booster to the “on” position. A green light will indicate that the
unit is now ready for use.
PLEASE NOTE: It is normal for the booster to be quite warm while the
phone is in use.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital devices, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of more of
the following measures:
Reorient or relocate the receiving antenna · Increase the separation between
the equipment and receiver · Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. · Consult the dealer or an
experienced radio/TV technician for help.
"Changes or modifications not expressly approved
by MCT, Inc., the party responsible for compliance,
could void the user's authority to operate the
equipment."
www.smoothtalker.com
Must be centered on Roof , Windsheild or Trunk
Antenna
Loading...