Smoke Factory ENTERPRISE TC4 Service Manual
SMOKE FACTORY
FOG & HAZE GENERATORS
ENTERPRISE TC4
SERVICE MANUAL
ATTENTION
!
Testing under 110-230V can be a danger for life.
The testing person should be a technical skilled
person to avoid injuries!
2
ENTERPRISE TC4 – SERVICE MANUAL
SMOKE FACTORY
FOG & HAZE GENERATORS
1. Introduction
1.1 General
This document should be used if ENTERPRISE TC4 is not working properly. With this document it
should be possible to find the fault/ not working device and change this device without the direct help
of the manufacturer.
ENTERPRISE TC4 has two pumps and thermocouples (2400W heater) and a connector for an
external fan. ENTERPRISE TC4 is available for 230V/50Hz.
1.2 Danger
- While replacing any device the power plug should be unplugged.
- While testing under life conditions (230V), never touch blank contacts.
2. Components
2.1 Pump EX5 230V/50Hz (50172), 120V/60Hz (59019)
Picture 2.1: Pump EX5 230V/50Hz (50172)
2.2 HE 2400 Heat Exchanger (part number 69022)
Picture 2.2.1b: Power connection
Picture 2.2.1a: HE2400 Heat Exchanger – ENTERPRISE TC4 (69022)
Therm
ostat
X1:3 X1:6
2.3 Circuit Boards
There are two boards: the PCB ENTERPRISE TC4 and the PCB Remote (DMX and analogue).
2.3.1 PCB ENTERPRISE TC4 (part number 39003)
Picture 2.3.1a: PCB ENTERPRISE TC4 – Top view (39003)
Picture 2.3.1d: Fuse on PCB ENTERPRISE TC4 board
Picture 2.3.1c: PCB ENTERPRISE TC4 – Bottom view
2.3.2 PCB Remote (DMX and analogue) (part number 39004)
Picture 2.3.2: PCB Remote (39004)
PCB
Power
Connector for
thermocouple
Power
terminal for
the fan
Solder
pads for
triac
Terminal block
ENTERPRISE TC4 – SERVICE MANUAL
3
SMOKE FACTORY
FOG & HAZE GENERATORS
2.4 Fuse holder IP67 (part number 40056)
Picture 2.4: Fuse holder (40056)
3. Diagrams
3.1 Part list ENTERPRISE TC4
Fuse holder
Connector for external fan
4
ENTERPRISE TC4 – SERVICE MANUAL
SMOKE FACTORY
FOG & HAZE GENERATORS
ENTERPRISE TC4 – SERVICE MANUAL
5
SMOKE FACTORY
FOG & HAZE GENERATORS
ENTERPRISE TC4
Loading...