SMK ZW4U2 User Manual

User Guide

INTRODUCTION

This product is a remote control. The Zagg remote is used only with the Teleportall Set
Box. The purpose of the remote is to control the set up box. Such functions as to change
channel, change volume, etc. The following is a picture of the remote:

OPERATION

Before using the remote please make sure the set up box is ready for operation. For this
please read the set up manual.

a) Once the set up box is ready for operation, pair the remote to the set up box. This

is done by following the instructions described in the monitor connected to the set

up box.
b) Point you remote to the set up box.
c) Press the key you desire.

INFORMATION TO USER

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interference
that may cause undesired operation.

This equipment has been tested and found to comply with the limits for Class B
Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures.

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.