SMK FC003 User Manual

User Manual

SMK Transceiver Module

MODEL RXX9000-09XXF

The purpose of this manual is to explain correct way how to integrate module
RXX9000-09XXF to the end product. It includes procedures that shall assist you to avoid
unforeseen problems. This manual presents information that shows how module and OEM
product, where module integrated, complies with regulations in certain regions. Any
modifications, not expressly approved by the manufacturer could void the authority to
operate in these regions.

The SMK Transceiver Module, model RXX9000-09XXF has to be installed and used in
accordance with the technical description/installation instructions provided by the
manufacturer.

For detail information concerning type approval of this module (e.g. where this module is
already pre-approved) please contact the authorized local distributor or the manufacturer.

The system may only be implemented in the configuration that was authorized. Note that
any changes or modifications to this equipment not expressly approved by the
manufacturer could void the user’s authority to operate this equipment.

Concept of SMK Transceiver Module, RXX9000-09XXF
This Module is a 2.4 GHz ISM band small-power transceiver module with a built-in
antenna. With UART and PWM output provided as an interface, sending and receiving of
wireless data is a matter of simplicity via UART. PWM can output received wireless data
in several decoded formats of remote control data.

Regulatory Information
USA-Federal Communications Commission (FCC)

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.

If this equipment does cause harmful interference to radio or television reception, which
can be determined by tuning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the distance between the equipment and the receiver.

-Connect the equipment to outlet on a circuit different from that to which the receiver is
connected.

-Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

Labelling
SMK Transceiver module RXX9000-09XXF labelled as below.

FCC ID:GT3FC003

The proposed FCC ID label format is to be placed on the module. If FCC ID is not visible
when the module is installed into the system, “Contains FCC ID:GT3FC003” shall be
placed on the outside of final host system.