Installation Instructions
02
-
06 Avalanche ½ & ¾ Ton
Sure-Step (Part # CN1190-S4)
00-07 Suburban/Yukon XL ½ & ¾ Ton
Read the instructions completely before you begin the installation. NOTE: Pictures are
for reference only, actual brackets may be different. Installation is the same
PARTS LIST
(2) SIDE TUBES WITH STEPS (4) ½” x 2” HEX HEAD BOLTS
(2) FRONT MOUNT BRACKETS (4) ½” FLAT WASHERS
(2) REAR MOUNT BRACKETS (4) ½” SPLIT LOCK WASHERS
(2) CENTER MOUNT BRACES (2)
(6) M12 – 1.75 x 120mm HEX HEAD BOLTS（ONLY FOR 00-06 MODEL）
(4)
5/16”
FLAT WASHERS
(2)
5/16”
SPLIT LOCK WASHERS
PROCEDURE
1. Begin installation by working on driver side of the vehicle (see Figures 1.1 – 1.4).
2. From underneath truck, loosen and remove body mount bolts that run upward through mounts into
floorboard. Attach and secure Front Mount Bracket to underside of vehicles front body mount (see Figure
1.2) with (1) M12 – 1.75 x 120mm bolt ( For 07 Model, use the factory bolt on the vehicle), (1) ½” split
lock washer, and (1) ½” flat washer. Hand Tighten.
3. Attach and secure Rear Mount Bracket to underside of vehicles rear body mount as shown in Figure 1.4, in
same manner as the front. Repeat for Center Brace,(see Figure 1.3).
4. Attach Side Tube to Front and Rear Brackets using (1) ½” x 2” bolt, (1) ½” lock washer and (1) ½” flat
washer for each bracket, and hand tighten. Fasten Center Brace to Side Tube using (1)
bolt,(1)5/16’’ Flat washer and (2)
tighten all bolts to complete the driver-side assembly.
5. Repeat process for passenger side of vehicle to complete installation.
5/16”
flat washer. Adjust Side Tube so that it is level and centered, and
5/16”
x 1” HEX HEAD BOLTS
5/16”
x 1”
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
02
-
06 Avalanche ½ & ¾ Ton
Sure-Step (Part # CN1190-S4)
00-07 Suburban/Yukon XL ½ & ¾ Ton
Figure 1.1 – Driver-Side Full Assembly View
½” x 2” Bolt
½” Washers
M12 – 1.75 x 120mm Bolt
Figure 1.2 – Front Bracket
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
02
-
06 Avalanche ½ & ¾ Ton
Sure-Step (Part # CN1190-S4)
00-07 Suburban/Yukon XL ½ & ¾ Ton
5/16” Hardware
Figure 1.3 – Center Brace
Cleaning and Maintenance
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish.
For stainless steel: aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap,
window or glass cleaner may be used also.
For gloss black finishes. Mild soap, window and glass cleaner may be used. Do not use any type of polish or
wax that contains abrasive that could damage the finish.
LIMITED WARRANTY
Smittybilt (The Company) warrants to the original purchaser of this product that should the product or any part thereof, under normal use and
conditions, be proven defective in material or workmanship within the warranty period of 5 years from the date of purchase, such defect(s) will be
repaired or replaced (At the Company’s option) without charge for parts or labor. To obtain repair or replacement within the terms of the warranty,
the product is to be delivered with proof of warranty coverage ( e.g. dated bill of sale, receipt), specification of defect, freight pre-paid with
Returns Good Authorization Number from Smittybilt to place of purchase. Items returned to Smittybilt Automotive without an Returns
Authorization Number will be refused and returned to sender at the senders expense.
This warranty does not apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through
altercation, improper installation, mishandling, misuse, neglect accident or acts of nature. THE EXTENT OF THE COMPANY’S LIABILITY
UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT,
SHALL THE COMPANY’S LIABILITY EXCEED THE PURCHASE PRICE PAID BY THE PURCHASER FOR THIS PRODUCT.
This warranty is in lieu of all expressed warranties and liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED
WARRANTY OF MERCHANTABILITY SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. ANY ACTION
FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY MUST BE
BROUGHTH WITHIN A PERIOD OF 90 DAYS FROM DATE OF ORIGINAL PURCHASE.IN NO CASE SHALL THE COMPANY BE
LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY,
EXPRESSED OR IMPLIED,WHATSOEVER. No person or representative is authorized to assume for the company any liability other than
expressed herein in connection with the sale of this product. Some states do not allow limitations on how long an implied warranty lasts or the
exclusion or limitation of incidental or consequential damage, therefore above limitations may not apply to you. This warranty gives the purchaser
specific legal rights. The purchaser may have additional rights, which vary from state to state. Some states do not allow limitations on how long
an implied warranty lasts or the exclusion or limitation of incidental or consequential damage, therefore above limitations may not apply to you.
This warranty gives the purchaser specific legal rights. The purchaser may have additional rights, which vary from state to state.
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Loading...