Smittybilt 941xx User Manual

Installation Instructions

(Part # 941xx JK 2

-Door)

Extended Top

(Part # 945xx JK 4-Door)

WWW.SMITTYBILT.COM

Note: Please read instructions thoroughly before installing this product. A windshield
header is required to install this. (Smittybilt part # 90105)

Step 1: Remove your hardtop or lower your soft top down (if equipped).
Step 2: Lay your top on its top on a clean surface. Remove the knobs and latch bracket from

your header and then slide header into the front of the top.
Connect the snaps on the top to the ones on the header. (Fig A, B)

Step 3: Lay the header on top of the windshield frame and spread top back over vehicle.
(Fig C)

(Fig A) (Fig B)

(Fig C) (Fig D)

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Installation Instructions

(Part # 941xx JK 2

-Door)

Extended Top

(Part # 945xx JK 4-Door)

WWW.SMITTYBILT.COM

Step 4: Reattach the brackets to the header using the knobs previously removed and secure
the header. (Fig D)

Step 5: Pull the center flap back over the sound pods and insert plastic hook into the hole.
(Fig E) Pull on strap and secure.

Step 6: Locate the straps in the rear corners. Wrap the straps around the sport bar and secure.
(Fig F)

(Fig E) (Fig F)
Step 7: Wrap the rear flap around the rear horizontal cross bar and secure the two straps.
(Fig G)

(Fig G) (Fig H)

Step 8: If your vehicle is equipped with factory door surrounds proceed, if not go to
Step 10.Slide the plastic strip sewn into the top into the plastic channel on the door

surrounds.(Fig H) Tuck the Velcro straps up under the top. Repeat this on each door
section of the top.

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220