Smittybilt 886308 User Manual

TOOLS REQUIRE

D

Figure

2 – Billet grille i

s

installed

IMPORTANT NOTICE:

Carefully read the instructions before attempting to install this product. The manufacturer is in no way responsible for any
damage to the vehicle or personal injury that may occur during the installation or use of this product.
NOTE: During shipping product might loose its convex shape or the bars may bend slightly. In order to get a proper fit,
product might need to be re-shaped slightly by bending it BY HAND to regain its convex shape. Be careful not to damage
the Billet Grille when bending.

Installation Instructions

Billet Grille (Overlay)

08-on SUPER DUTY BUMPER INSERT

PART#: 886308

INCLUDED COMPONENTS

1 – Billet Grille(1 piece)
4 – Metal Brackets
8 – M4 x 20mm Phillips Screws
8 – M4 Flange Nuts

INSTALLATION INSTRUCTIONS

1. Inspect product and check components with items listed above.

2. Position the Bumper Billet onto grille shell cavity.

3. Loosely attach the billet grille by holding metal brackets behind factory grille shell and insert phillips screws (from
the front) through the billet grille holes and metal brackets, secure them with flange nuts provided as shown in
Figure 3.

4. Adjust billet grille to the position you like then tight the screws.

Figure 1 – Included Hardware

Figure 3 – Billet grille is secured on bumper

- Phillips Screw Driver

- 4mm wrench

Smittybilt Automotive Products 400 W. Artesia Blvd, Compton CA. 90220

Phone [phone] Fax [phone]

886308