Smittybilt 7700 User Manual

Receiver Rack (Part # 7700)

(Large) 10mm x 75mm Bolt 3

4

Installation Instructions

Universal Application

NOTE: Carefully read entire instructions thoroughly before

attempting to install this part.

Parts Included Qty Tools Needed

2 “ Draw Bar 1
Racks 2
Curved Support Bars 2
Connecting Plates 2

(Medium) 10mm x 25mm Bolt
(Large) 10mm Flat Washer 7
(Large) 10mm Lock Nut 7
(Small) 6mm x 18mm Bolt 12
(Small) 6mm Flat Washer 12
(Small) 6mm Lock Nut 12

Ratchet

Socket Set

Wrench Set

!

CAUTION: Never exceed the tongue weight capacity of your hitch.

Never exceed the weight limit of the Receiver Rack (500 LB’s evenly distributed).

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd,Compton CA 90220

Receiver Rack (Part # 7700)

Installation Instructions

Universal Application

Step 1: Connect the two racks together by attaching the two plates to the outside of the racks using the (12)
6mm “Small” bolts, (12) 6mm flat washers and (12) 6mm lock nuts. (Fig 1)

(Small) 6mm Bolt
& 6mm Washer

6mm Lock Nut

(Figure 1)

Step 2: Tighten all bolts installed in Step1. Now locate the (3) holes down the center of the rack.

Step 3: Slide the drawbar under the rack and attach by inserting (1) “Large” 10mm x 75mm bolt, washer and

lock nut into the center hole only. (Fig 2, 3)

Center Hole

Large Bolt

Figure 3

Washer

Draw Bar

Large Lock Nut

Metal Plate

Receiver Rack

Figure 2

Receiver Rack

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd,Compton CA 90220