Smittybilt 76911 User Manual
Installation Instructions
Parts Included Qty
Parts Included Qty
Light Bar Part # 76911
07-11 Wrangler &Unlimited
WWW.SMITTYBILT.COM
Light Bar Part # 76910
97-06 Wrangler and Unlimited
Note: Read instructions entirely before installing this product.
Driver Side Upright 1
Passenger Side Upright 1
Center Bar 1 Closed End Cap 2
Open End Cap 2
3/8” x 1 ½” Bolt 2
3/8” Flat Washer 2
Step 1: Remove five of the factory bolts on the driver side windshield frame bracket. (Fig A)
Step 2: Remove the same bolts on the passenger side.
Step 3: Install each side upright bracket using the previously removed five factory bolts. Do not fully secure
at this time. Use caution when doing this in order to protect the finish of your vehicle.
Step 4: Push on the open ended style end caps on the ends of the top of the uprights. (Fig B)
Step 5: With assistance install the center light bar section using the included hardware. (Bolt and Flat
Washer) Note: The light mounting tabs point towards the rear of the vehicle with the flat
surface facing up.
(Fig A) (Fig B) (Fig C)
Step 6: Tighten the two end bolts completely making sure the center light bar is at your desired position.
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Light Bar Part # 76911
07-11 Wrangler &Unlimited
WWW.SMITTYBILT.COM
Light Bar Part # 76910
97-06 Wrangler and Unlimited
Step 7: Secure the windshield bracket bolts that you re-installed on Step 3 completely.
Step 8: Carefully install the closed end caps in each end of the light bar. (Fig C)
Step 9: Installation is now complete. (Fig D) You may now install lights per manufacturers’ instructions.
Compliment your light bar with
Smittybilts windshield bracket light
mounts (Part# 7690) and Pro Comp
L.E.D lights.
(Fig D)
Limited Warranties
Smittybilt’s products are covered under the following limited warranties only. Note that the duration of the limited warranty differs according to the
material and finish of the product purchased. Subject to the duration and conditions of the limited warranty stated below, Smittybilt warrants to the
original retail purchaser that its products are free from defects in material and workmanship. All other warranties and representations express or
implied, are hereby disclaimed, including fitness for merchantability and buyer’s intended use or purpose. All parts are sold “AS IS” except for the
limited warranties granted herein. Buyer assumes all risks as to the selection, suitability and performance of all goods and products selected. This
limited warranty does not cover damage or impairment in any part due to misuse, improper installation, accident or contact with on-road or off-road
hazards, product modification, improper or inadequate cleaning and/or maintenance. Smittybilt is not responsible for items damaged during shipping.
This warranty is not transferable from the original buyer. For the original Buyer to be eligible for the limited warranty coverage, the Buyer must provide
proof of purchase. Smittybilt strongly recommends returning the warranty registration card.
Customer’s remedy hereunder shall be limited only to repair or replacement (at Smittybilt’s option) of any defective part(s) returned to Smittybilt at
customer’s expense. The determination of whether or not a returned part is defective or subject to coverage under the limited warranties stated
herein shall be made at Smittybilt’s sole discretion.
1. Limited Five (5) Year / 50,000 Mile Pro-Rata Warranty (whichever occurs first) on Dual-Stage Powder Coating Products -
Smittybilt dual-stage powder coated products carry the foregoing limited repair or replacement warranty for a period of (5) years or 50,000 miles
(whichever occurs first) from date of purchase against workmanship and defects in the material, provided that any claim submitted after (2.5)
years from date of purchase shall, if accepted, be satisfied by Smittybilt offering customer a credit on the purchase of a replacement product
equal to fifty percent (50%) of customer’s initial purchase price.
To assure product quality, Smittybilt reserves the right to change product design, material, specification and finishes without prior notice to customers.
This limited warranty gives you specific legal rights and you may also have other rights, which may vary from state to state. Some states do not allow
limitations on how long an implied warranty lasts, so the above limitations may not apply as to you. Also, some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. Smittybilt reserves the right to
discontinue product lines and substitute products, or provide other remedies than those listed in this limited warranty for those discontinued products.
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Loading...