Smittybilt 76635-SRC User Manual

Installation Instructions
SRC Classic Sides (Part # 76635)
07-10 Jeep Wrangler (2-Door)
WWW.SMITTYBILT.COM
NOTE: Carefully read entire instructions thoroughly
Parts Included Qty Pa
Driver Side Bar 1 Passenger Side Bar 1 Nut-Clip 6mm Ny-lock Nut 8
Step 1: Step 2:
the passenger side guard onto the ve on the guard with the already existi (Fig A)
Step 3:
Nut-clips will be inserted into by w remove some tape that is applied fro Fig B,C,D
Remove oem or aftermarket side rails/steps if eq Identify the passenger and driver side.(The shor
Identify the two holes (one front and one back)
4
ng holes on the pinch weld area of your vehicle.
here the top brackets align with. (You may need to
m the factory that is covering the holes)
hicle by lining up the 4 tabs (2 front and 2 back)
before attempting to install this part.
rts Included Qty
10 x 25mm Hex Bolt 4 10mm Flat Washer 4 6mm Flat Washer 8
uipped. (Fig A)
t end goes towards the front) Place
on the bottom of the body that the
Line up the 4 tabs (2 front and 2 back) on the guard with the already existing holes on the pinch weld area of your vehicle.
(Fig A) (Fig B)
Step 4:
nut clips and 6mm lock-nuts onto the bracket studs that go through the pinch weld area. (Fig D) Once you have attached completely. Installation is now complete, pro (Fig E)
Loosely attach the guard to the vehicle by inser
the front and rear bolts and nuts, you may tighten
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
You may need to remove some tape that is applied from the factory that is covering the holes. (Front passenger side pictured)
ting the 2-10mm hex bolts into the
ceed to other side and follow same steps.
Installation Instructions
with.
studs.
SRC Classic Sides (Part # 76635)
07-10 Jeep Wrangler (2-Door)
WWW.SMITTYBILT.COM
Identify the two holes (one front and one back) on the bottom of the body that the Nut-clips will be inserted into by where the top brackets align
Insert clip into body by sliding it in through the square hole next to it
(Fig C) (Fig D)
Loosely attach the guard to the vehicle by inserting the 2-10mm hex bolts into the nut clips and 6mm lock­nuts onto the bracket
CARE AND MAINTENANCE
To protect your investment it is recommended to regularly wash and wax this part. Do not use any type of cleaners that contain abrasives that may damage the finish of your part.
(Fig E)
Smittybilt (The Company) warrants to the original purchaser of this product that should the product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 5 years from the original date of purchase, such defect(s) will be repaired or replaced (At the Company’s option) without charge for parts or labor. To obtain repair or replacement within the terms of the warranty, the product is to be delivered with proof of warranty coverage ( e.g. dated bill of sale, receipt), specification of defect, freight pre-paid with Returns Good Authorization Number from Smittybilt to place of purchase. Items returned to Smittybilt without a Returns Authorization Number will be refused and returned to sender at the sender’s expense. This warranty does not apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through altercation, improper installation, mishandling, misuse, neglect accident or acts of nature. THE EXTENT OF THE COMPANY’S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE
REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY’S LIABILITY EXCEED THE PURCHASE PRICE PAID BY THE PURCHASER FOR THIS PRODUCT. This warranty is in lieu of all expressed warranties and liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY SHALL BE
LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY MUST BE BROUGHTH WITHIN A PERIOD OF 90 DAYS FROM DATE OF ORIGINAL PURCHASE.IN NO CASE SHALL THE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED,WHATSOEVER. No person or representative is authorized to assume for the company any liability other than expressed herein in connection with the sale of this product. Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damage, therefore above limitations may not apply to you. This warranty gives the purchaser specific legal rights. The purchaser may have additional rights, which vary from state to state.
LIMITED WARRANTY
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220