Smittybilt 76632-SRC User Manual

Mounting Location

LEADING MANUFACTURER OF TUBULAR PRODUCTS SINCE 1956!

NOTE: Please read this information before installing. To obtain correct installation, we recommend you to follow these

step by step installation instructions carefully. Please take care when installing this product to protect the finish and your
investment. DRILLING REQUIRED

Step One: Locate hardware and check contents with the hardware listed below.

QTY DESCRIPTION

1 Side Guard Set (Left and Right)
16 3/8” x 1” Self Tapping Bolts

Step Two: Position the Guard up to the frame. Maintain a ½” minimum between the bottom of vehicle and the top of the
Guard. Move the Guard from front to back till is parallel to the side of the frame. Also make sure it is parallel to the
bottom of the vehicle. Assistance is recommended while positioning Guard up to frame.

Step Three: Mark the side of the frame through the mounting holes located in the Guard Bracket. Then place Guard
aside. Center punch the frame where you marked and drill a 5/16” hole in the frame. CAUTION: Before drilling be sure
to check the backside of the frame for possible hazards or obstructions.

Step Four: Position Guard back to the frame and line up holes in the mounting brackets with just drilled holes in the
frame. Secure the Guard to the frame with the included 3/8” x 1” Self Tapping bolts. Fully tighten all hardware at this
time. Be sure to use all hardware supplied and tighten all bolts.

Step Five: Repeat steps two through four for the opposite side.

These Side Guards are genuine SMITTYBILT, INC. precision built guards that mount to your vehicle for that clean
look and added protection. They have been designed and engineered to give long lasting service and beauty to your
vehicle. Thank you for choosing a SMITTYBILT, INC. product.

To enhance the looks of your vehicle, Smittybilt also offers an “OUTLAND” front guard, SURE-STEP side bars,
bumper thumpers and brush guards for your vehicle made only by SMITTYBILT, your tubing specialist since 1956!

For Technical Support / Warranty Information, please call: 951-736-8686

Side Rocker Guard Shown Side Armor Guard Shown

Drilling and

Installation Instructions

SRC Side Armor / Rocker Guards

87-on Wrangler

Drilling and

Mounting Location

SMITTYBILT, INC., 1550 Magnolia Suite 101, Corona, CA 92879 Made In China INST7663x and 7664x Rev A