Smittybilt 7610xx User Manual

Included Components

QTY

Installation Instructions

Tonneau Cover (#7610xx)

1997-2006 Jeep Wranglers

Before You Begin

Thank you for purchasing the Smittybilt Tonneau Cover for 1997-Current Jeep Wrangler.
Before you get started, please read the important information listed below:

1. For this Tonneau Cover to fit correctly you must have Soft Top equipment, factory
installed hardware on your vehicle.

2. All Smittybilt Soft tops are pre-fit at the factory. Please note that in order to provide long
term fit, Smittybilt designs each top to fit very tight on the initial installation. Please
make sure it is at least 70 degrees F. when you first install this top or it will be very
difficult to install. If you use a hair dryer to warm the fabric, the install will be easier.

3. The Tonneau Cover may seem wrinkled when first installed, this is caused by the fabric
becoming wrinkled during shipping. The fabric and the wrinkles will relax after a few
days installed on the vehicle.

Warning: this top is designed to protect you from the elements only and is not designed

!

to keep you inside the vehicle in the event of an accident. Always fasten your seat belt.

 IF YOU HAVE ANY PROBLEMS WITH THE INSTALLATION OR PERFORMANCE OF THIS

TONNEAU COVER , DO NOT RETURN THE PRODUCT TO THE RETAILER. PLEASE CALL
1-888-717-5797 FOR INSTALLATION HELP. FACTORY TRAINED PERSONNEL WILL BE
ABLE TO WALK YOU THROUGH THE INSTALLATION/PROBLEM.

1. Tonneau Cover (1)

2. Captive Screw (3)

3. Nut (3)

4. Black Thick Washer (6)

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd,, Compton, CA 90220

Installation Instructions

Tonneau Cover (#7610xx)

1997-2006 Jeep Wranglers

Installation Instructions

1. Lay the Tonneau over vehicle and wrap around the roll bar at the rear of the vehicle (Figure 1).

2. Lift flap on rear of Tonneau and slide factory tailgate channel on Tonneau retainer. Insert channel
back onto vehicle (Figures 2 and 3).

Figure 2

3. Starting at the rear of the vehicle, insert the plastic retainer strip (sewn into Tonneau) into the soft-top
channel. Work towards the front pulling the Tonneau forward. Complete for the driver, passenger, and
rear sides (Figure 4).

Figure 1

Figure 3

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd,, Compton, CA 90220