Smittybilt 581035 User Manual

Installation Instructions

Please read instructions enti

rely before installing this part

Step 3:

C-RES (Cargo Restraint System)

07-10 Unlimited (4-Door)

WWW.SMITTYBILT.COM

Part #581035

NOTE: You will need to have the following to install this part correctly.

1. Tailgate retaining bar and brackets.

Step 1: To avoid damage to your CRES It is recommended to remove your soft top to install
this product.Remove your existing soft top at this time (If equipped)

Step 2: Unfold the C-RES top and lay it our over the rear of the vehicle. (Fig A)
Step 3: Starting on the driver side attach the plastic channel in the top into the front edge of

retaining channel the body tub next to the door opening. Then continue down the side
and around the rear corners. (Fig B) Repeat on the passenger side. If installing with the
OEM door surrounds continue to Step 4, if you are installing without the proceed to
Step 9.

Unfold the C-RES top and lay it our

over the rear of the vehicle.

Starting on the driver side attach the
plastic channel in the top into the front edge of
retaining channel the body tub next to the door
opening. Then continue down the side and

(Fig A) (Fig B)
Step 4: Begin inserting the plastic channel in the top into the vertical part of the door surround

on the driver side. (Fig C)

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Installation Instructions

Fig E Fig F

sound pods.

C-RES (Cargo Restraint System)

07-10 Unlimited (4-Door)

WWW.SMITTYBILT.COM

Part #581035

Step 5: Now insert the plastic channel on the top into the top horizontal part of your
door surrounds. (Fig D) Repeat step 4 and 5 on the passenger side now.

Insert the plastic channel on the top into the
top horizontal part of your door surrounds

Insert the plastic channel in
the top into the vertical part
of the door surround.

(Fig C) (Fig D)
Step 6: Loosely attach the two top straps around the sport bar into the factory holes in the

sound pods. (Fig E)
Step 7: Slide your tail-gate retaining bar into the sewn in extrusion on the back of your top

(Fig F) Once all the way on lock the bar into the brackets (Fig G)

Slide your tail-gate
retaining bar into the
sewn in extrusion on
the back of your top

Loosely attach
the two top
straps around
the sport bar
into the factory
holes in the

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220