Installation Instructions
C-RES (Cargo Restraint System)
07-10 Jeep Wrangler (2-Door)
WWW.SMITTYBILT.COM
Part #571035
NOTE: You will need to have the following to install this part correctly.
1. Tailgate retaining bar and brackets.
2. OEM Door-Surrounds
Step 1: It is recommended to remove your soft top and bow assembly completely to install
this product. Remove your existing soft top and bow assembly (If equipped)
Step 2: Unfold the C-RES top and lay it our over the rear of the vehicle. (Fig A)
Step 3: Starting on the driver side attach the plastic channel in the top into the back channel
of your door surround. (Fig B)
Please read instructions entirely before installing this part
Unfold the C-RES top and lay it our
over the rear of the vehicle.
(Fig A) (Fig B)
Step 4: Begin sliding the side channel on the top into the side channel on your vehicle and
continue around the corners.(Fig C) Repeat step 3 and 4 on passenger side.
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Attach the plastic channel in the
top into the back channel of your
Installation Instructions
C-RES (Cargo Restraint System)
07-10 Jeep Wrangler (2-Door)
WWW.SMITTYBILT.COM
Part #571035
Step 5: Now insert the plastic channel on the top into the top horizontal part of your
door surrounds. (Fig D) Repeat step 4 and 5 on the passenger side now.
(Fig C) (Fig D)
Step 6: Loosely attach the two top straps around the sport bar into the factory holes in the
sound pods. (Fig D) (Do not pull tight at this time.)
Step 7: Slide your tail-gate retaining bar into the sewn in extrusion on the back of your top
(Fig F) Once all the way on lock the bar into the brackets (Fig G)
Slide your tail-gate
retaining bar into the
sewn in extrusion on
the back of your top
Once the retaining bar is all the way on, lock the
bar into the brackets.
(Fig E) (Fig F)
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220