Smittybilt 5680 User Manual

Installation Instructions

Parts Included Qty

Parts Included Qty

Front Euro Headlight Guards

Part # 5680

WWW.SMITTYBILT.COM

07-11 Wrangler & Unlimited

Headlight Guard 2 Self-tapping Screw 4

Step 1: Insert the top of the light guard (tab with pad) between the headlight surround and the grille.
(Fig A) The light guard bars should be vertical.

Step 2: Push the guard back flush towards the light. Making sure the guard is straight mark a hole
through the lower two tabs. (Fig B

Note: Read instructions entirely before installing this accessory.

(Fig A) (Fig B)
Step 3: Remove guard and set to the side. Using a 1/16” drill bit, drill the previously marked two
hole locations. (Fig C) Note: Always use caution and care when drilling

Step 4: Re-install light guard on headlight; by following the previous instructions and line up the
tabs with the holes you just drilled. Secure with the included screws. (Fig D)

Fig C Fig D

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Installation Instructions

Front Euro Headlight Guards

Part # 5680

WWW.SMITTYBILT.COM

07-11 Wrangler & Unlimited

Step 5: Tighten screws snug. Do not over tighten. Use same steps for the other side. Installation is now
complete. (Fig F)

Before After

Smittybilt’s products are covered under the following limited warranties only. Note that the duration of the limited warranty differs according to the material and finish of the
product purchased. Subject to the duration and conditions of the limited warranty stated below, Smittybilt warrants to the original retail purchaser that its products are free
from defects in material and workmanship. All other warranties and representations express or implied, are hereby disclaimed, including fitness for merchantability and
buyer’s intended use or purpose. All parts are sold “AS IS” except for the limited warranties granted herein. Buyer assumes all risks as to the selection, suitability and
performance of all goods and products selected. This limited warranty does not cover damage or impairment in any part due to misuse, improper installation, accident or
contact with on-road or off-road hazards, product modification, improper or inadequate cleaning and/or maintenance. Smittybilt is not responsible for items damaged during
shipping. This warranty is not transferable from the original buyer. For the original Buyer to be eligible for the limited warranty coverage, the Buyer must provide proof of
purchase.

Customer’s remedy hereunder shall be limited only to repair or replacement (at Smittybilt’s option) of any defective part(s) returned to Smittybilt at customer’s expense.
The determination of whether or not a returned part is defective or subject to coverage under the limited warranties stated herein shall be made at Smittybilt’s sole
discretion.

To assure product quality, Smittybilt reserves the right to change product design, material, specification and finishes without prior notice to customers. This limited warranty
gives you specific legal rights and you may also have other rights, which may vary from state to state. Some states do not allow limitations on how long an implied
warranty lasts, so the above limitations may not apply as to you. Also, some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you. Smittybilt reserves the right to discontinue product lines and substitute products, or provide other remedies than
those listed in this limited warranty for those discontinued products.

(Fig E) (Fig F)

Note: To complete your front end light protection; purchase Smittybilt front turn
signal light guards. Part # .Taillight guards are also available; Part #8665

Limited Warranties

1. Limited Five (5) Year / 50,000 Mile Pro-Rata Warranty (whichever occurs first) on Dual-Stage Powder Coating Products -

Smittybilt dual-stage powder coated products carry the foregoing limited repair or replacement warranty for a period of (5) years or 50,000 miles (whichever occurs
first) from date of purchase against workmanship and defects in the material, provided that any claim submitted after (2.5) years from date of purchase shall, if
accepted, be satisfied by Smittybilt offering customer a credit on the purchase of a replacement product equal to fifty percent (50%) of customer’s initial purchase
price.

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220