Smittybilt 561035 User Manual
Installation Instructions
C-RES
(Cargo Restraint System)
Part # 521035 (92-95 Wrangler)
WWW.SMITTYBILT.COM
Part # 561035 (97-06 Wrangler)
NOTE: You will need to have the following to install this part correctly.
1. (YJ) Softop retaining channels on the side and corners of the body tub.
(OEM or aftermarket will work), Tailgate retaining bar and brackets.
2. (TJ) Tailgate retaining bar and brackets.
Step 1: Remove or fold down, your existing soft top and bow assembly (If equipped)
If you fold down you your top make sure bow assembly is all the way down and
top is tucked in per manufacturers instructions.
Step 2: Unfold the C-RES top and lay it our over the rear of the vehicle. (Fig A)
Step 3: Starting on the driver side attach the plastic channel in the top into the front edge of
retaining channel the body tub next to the door opening. Then continue down the side
and around the rear corners. (Fig B) Repeat on the passenger side.
Please read instructions entirely before installing this part
(Fig A) (Fig B)
Step 4: Begin fastening the 3 straps along the top around the sport bar. (Fig C) Do not fully
tighten at this time.
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Fig F Fig G
C-RES
(Cargo Restraint System)
Part # 521035 (92-95 Wrangler)
WWW.SMITTYBILT.COM
Part # 561035 (97-06 Wrangler)
Step 5: Fasten the two side straps along the side of the sport bar. (Fig D)
Note: If you have a TJ and keep the door surrounds on, simply tuck the bottom
buckle under the top. (Fig E) Do not fully tighten at this time.
Begin fastening the 3 straps along
the top around the sport bar.
The corner
straps go
around the
side sport
bar.
If you have a TJ and keep the
Fasten
the two
side
straps
along the
side of
the sport
bar.
door surrounds on, simply tuck
the bottom Buckle under the
top.
(Fig C) (Fig D) (Fig E)
Step 6: Slide your tail-gate retaining bar into the sewn in extrusion on the back of your top
(Fig F) Once all the way on lock the bar into the brackets (Fig G)
Slide your tail-gate
retaining bar into the
sewn in extrusion on
the back of your top
Lock the bar into
the brackets.
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Loading...