Smittybilt 55112 User Manual

Installation Instructions

Bull Bar (#55111&55112)

99-06 Ford Super Duty

NOTE: Please read this information before assembling. Complete step by step instruction sheets will be found on the
following page. The “SMITTYBILT” one-piece front guard has been designed to be installed on vehicle in one
complete stage. NO DRILLING REQUIRED

Please take care when assembling and installing this product to protect the finish and your investment. To protect your
investment, wax this product after installing. Regular waxing is recommended. Do not use any type of polish or wax
that contains abrasive that could damage the finish.

Step One: Locate hardware and check the contents with the hardware listed below.

QTY DESCRIPTION
1 Grille Saver

2 Mounting Brackets (Passenger & Driver)
4 3/8 x 1 ¼ hex head bolt, zinc plated
8 3/8 flat washers, zinc plated
4 3/8 lock washers, zinc plated
4 3/8 hex nuts, zinc plated

Step Two:

retain for later use . (NOTE: In order to use factory tow hooks with Front Guard, you must reverse them before
installing the Mounting Brackets.) (Fig 1)

Step Three:

Step Four:

.

Step Five: Center Guard and tighten hardware

Remove the factory tow hooks (if equipped) and the two bumper brackets and hardware from both sides and

Using the factory hardware removed in Step Two, loosely attach Mounting Brackets to vehicle (Fig 1).

Use the 3/8 hardware listed above to attach the Grille Saver to the Mounting Brackets installed in step three.

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220

Installation Instructions

Bull Bar (#55111&55112)

99-06 Ford Super Duty

Fig 1

Factory Bolts

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220